PAROC Hvac GreyCoat. For a better appearance

Transcription

1 PAROC Hvac GreyCoat For a better appearance Technical Insulation Product information September 2013

2 PAROC Hvac GreyCoat GreyCoat is a new, PVC free facing for PAROC Hvac products. With PAROC Hvac GreyCoat products you will get an attractive result without any additional cladding or painting, and by quick and easy installation you will save both time and money. PAROC Hvac GreyCoat products offer you a full system for easy installation with pipe sections and tape. Appearance GreyCoat is a light grey, reinforced aluminium based facing with lacquer on top. PAROC Hvac GreyCoat products produce an attractive appearance without any additional cladding or painting. You save time while getting a clean, good-looking installation. PAROC Hvac GreyCoat products are ideal for HVAC installations in places where the installation is visible, such as shopping malls, public buildings and sport halls. Fire classification PAROC Hvac GreyCoat flat products are Euroclass A2-s1, d0 classified and PAROC Hvac GreyCoat sections are A2 L -s1, d0 classified, which means that they do not contribute to flashover, create a very limited amount of smoke and do not create burning droplets. Ventilation duct insulated with PAROC Hvac Lamella Mat GreyCoat smoothly blends in to the background. 2

3 Vapour barrier PAROC Hvac GreyCoat products are thermal insulation products. GreyCoat facing works as a vapour barrier, therefore GreyCoat faced slabs, lamella mats and mats can also be used for condensation insulation. For condensation insulation, use GreyCoat tape for the seams. Installation Easy installation saves time and money. Use GreyCoat tape to finish off the look and provide protection against condensation. PAROC GreyCoat products can offer a quick and easy way to get the look you want without additional painting or cladding. PAROC Hvac GreyCoat benefits: Fire classification: Flat products A2-s1, d0 Sections A2 L -s1, d0 Better appearance No additional painting or cladding is needed PVC free Quick installation Cost effective solution Full solution for ventilation ducts and HVAC pipes also pipe elbows including GreyCoat tape. 3

4 PAROC Hvac Lamella Mat GreyCoat PAROC Hvac Lamella Mat GreyCoat is a non-combustible stone wool for thermal and condensation insulation of ventilation ducts and equipment. It has a reinforced grey alumium foil facing. Fire Properties Surface temperature of the facing must not exceed 80 C (temperature restriction determined in accordance with heat resistance adhesive). PAROC stone wool products are capable of withstanding high temperatures. The binder starts to evaporate when its temperature exceeds approximately 200 C. The insulating properties remain unchanged, but the compressive stress weakens. The softening temperature of stone wool products is over 1000 C. Dimensions Width x Length Thickness Width 1000 or 500 mm. Lenght mm depending on thickness mm Standard EN 822 Standard EN 823 Dimensions and Tolerances T4 EN 14303:2009 (EN 14303) Packaging Package Type Plastic Packs on Pallet Reaction to Fire Reaction to Fire, Euroclass A2-s1, d0 EN 14303:2009 (EN ) Thermal Resistance Thermal Conductivity (declared) in 10 C, λ W/mK EN 14303:2009 (EN 12667/EN 12939) Thermal Conductivity (declared) in 50 C, λ W/mK Thermal Conductivity (declared) in 100 C, λ W/mK Thermal Conductivity (declared) in 150 C, λ W/mK Thermal Conductivity (declared) in 200 C, λ W/mK Thermal Conductivity (declared) in 250 C, λ W/mK Water Permeability Water Absorption, Short Term WS, Wp 1 kg/m² EN 14303:2009 (EN 1609) Water Vapour Permeability Water Vapour Diffusion Resistance MV2 EN 14303:2009 (EN 12086) Trace Quantities of Water Soluble Ions and the ph Value Chloride Ions, Cl- < 10 ppm EN 14303:2009 (EN 13468) 4

5 PAROC Hvac Slab GreyCoat PAROC Hvac Slab GreyCoat is a non-combustible stone wool slab for thermal and condensation insulation of ventilation ducts and equipment. It has a reinforced grey aluminium foil facing. Fire Properties Surface temperature of the facing must not exceed 80 C (temperature restriction determined in accordance with heat resistance adhesive). PAROC stone wool products are capable of withstanding high temperatures. The binder starts to evaporate when its temperature exceeds approximately 200 C. The insulating properties remain unchanged, but the compressive stress weakens. The softening temperature of stone wool products is over 1000 C. Dimensions Width x Length Thickness 600 x 1200 mm mm Standard EN 822 Standard EN 823 Dimensions and Tolerances T5 EN 14303:2009 (EN 14303) Packaging Package Type Plastic Packs on pallet Reaction to Fire Reaction to Fire, Euroclass A2-s1, d0 EN 14303:2009 (EN ) Thermal Resistance Thermal Conductivity (declared) in 10 C, λ W/mK EN 14303:2009 (EN 12667/EN 12939) Water Permeability Water Absorption, Short Term WS, Wp 1 kg/m² EN 14303:2009 (EN 1609) Water Vapour Permeability Water Vapour Diffusion Resistance MV2 EN 14303:2009 (EN 12086) Trace Quantities of Water Soluble Ions and the ph Value Chloride Ions, Cl- < 10 ppm EN 14303:2009 (EN 13468) Chloride content not declared for products produced in Hällekis. 5

6 PAROC Hvac Fire Mat GreyCoat PAROC Hvac Fire Mat GreyCoat is a non-combustible stone wool wired mat. It is used for thermal and fire insulation of circular and rectangular ventilation ducts. It has a reinforced grey aluminium foil facing. Fire Properties Surface temperature of the facing must not exceed 80 C. PAROC stone wool products are capable of withstanding high temperatures. The binder starts to evaporate when its temperature exceeds approximately 200 C. The insulating properties remain unchanged, but the compressive stress weakens. The softening temperature of stone wool products is over 1000 C. Dimensions Width x Length Thickness Width 500/600/900/1000 mm, lenght depending on thickness mm Standard EN 822 Standard EN 823 Dimensions and Tolerances T2 EN 14303:2009 (EN 14303) Packaging Package Type Plastic Packs on Pallet Reaction to Fire Reaction to Fire, Euroclass A2-s1, d0 EN 14303:2009 (EN ) Thermal Resistance Thermal Conductivity (declared) in 0 C, λ W/mK Thermal Conductivity (declared) in 10 C, λ W/mK Thermal Conductivity (declared) in 50 C, λ W/mK Thermal Conductivity (declared) in 100 C, λ W/mK Thermal Conductivity (declared) in 200 C, λ W/mK Thermal Conductivity (declared) in 300 C, λ W/mK Thermal Conductivity (declared) in 400 C, λ W/mK Thermal Conductivity (declared) in 500 C, λ W/mK Thermal Conductivity (declared) in 600 C, λ600 0,204 W/mK Water Permeability Water Absorption, Short Term WS, Wp 1 kg/m² EN 14303:2009 (EN 1609) Trace Quantities of Water Soluble Ions and the ph Value Chloride Ions, Cl- < 10 ppm EN 14303:2009 (EN 13468) 6

7 PAROC Hvac Section GreyCoat T PAROC Hvac Section GreyCoat T is a non-combustible stone wool pipe section for thermal and condensation insulation of pipework and air ducts in buildings. It has a reinforced grey aluminium foil facing and tape in the longitudinal seam which prevents condensation and gives a quick installation. Fire Properties Surface temperature of the facing must not exceed +80 C (temperature restriction determined in accordance with heat resistance of adhesive). PAROC stone wool products are capable of withstanding high temperatures. The binder starts to evaporate when its temperature exceeds approximately 200 C. The insulating properties remain unchanged, but the compressive stress weakens. The softening temperature of stone wool products is over 1000 C. Dimensions Thickness Inner Diameter Pipe Section Length mm mm 1200 mm Standard EN Standard EN Standard EN Dimensions and Tolerances T8/T9 EN 14303:2009 (EN 14303) Packaging Package Type Cartons or plastic packs on pallet Reaction to Fire Reaction to Fire, Euroclass A2 L s1, d0 EN 14303:2009 (EN ) Thermal Resistance Thermal Conductivity (declared) in 10 C, λ W/mK EN ISO 8497 Thermal Conductivity (declared) in 50 C, λ W/mK Thermal Conductivity (declared) in 100 C, λ W/mK Thermal Conductivity (declared) in 150 C, λ W/mK Water Permeability Water Absorption, Short Term WS, Wp 1 kg/m² EN 14303:2009 (EN 13472) Water Vapour Permeability Water Vapour Diffusion Resistance MV2 EN 14303:2009 (EN 13469) 7

8 Paroc is the leading manufacturer of energy-efficient insulation solutions in the Baltic Sea region. The cornerstones of our operations are customer and personnel orientation, constant innovation, profitable growth and sustainable development. Paroc products include building insulation, technical insulation, marine and offshore insulation, sandwich panels and acoustic products. The products are manufactured in Finland, Sweden, Lithuania and Poland and as of 2013 also in Russia. Paroc has sales and representative offices in 14 European countries. Building Insulation offers a wide range of products and solutions for all traditional building insulation. The building insulation products are mainly used for the thermal, fire and sound insulation of exterior walls, roofs, fl oors and basements, intermediate fl oors and partitions. Sound absorbing ceilings and wall panels for interior acoustic control, as well as industrial noise control products, are available in the range. Technical Insulation products are used for thermal, fire and sound insulation in building techniques, industrial processes and pipe work, industrial equipment and ship structures. Sandwich panels are fire proof lightweight steel-faced panels with a core material of stone wool. Paroc panels are used for façades, partitions and ceilings in public, commercial and industrial buildings. The information in this brochure describes the conditions and technical properties of the disclosed products, valid at the time of publication of this document and until replaced by the next printed or digital version. The latest version of this brochure is always available on Paroc web site. Our information material presents applications for which the functions and technical properties of our products have been approved. However, the information does not mean a commercial guarantee, since we do not have full control of third party components used in the application or the installation. We cannot warrant the suitability of our products if used in an area which is not provided in our information material. As a result of constant further development of our products we reserve the right to make alterations to our information material. PAROC and red and white stripes are registered trademarks of Paroc Oy Ab. Paroc Group TIEN0913 PAROC OY AB Technical Insulation Energiakuja Helsinki, Finland Tel Fax technical.insulation@paroc.com A MEMBER OF PAROC GROUP