Full Figure Santa Claus Stocking Pattern #9005C

Transcription

1 Published on Knitting Patterns ( Home > Printer-friendly PDF > Printer-friendly PDF Full Figure Santa Claus Stocking Pattern #9005C This free pattern originally published in: Grace Ennis Graphic Knitting Patterns

2 Simplified multi-color knitting with color charts. Stitch sequences numbered. Each row knitted across and purled back in the same colors. Knit your own choice of name and year, if you wish. Large size approximately 21 inches top-to-toe. IMPORTANT Knit across and purl back each row before starting next row. Use size NUMBER THREE needles and regular 4-ply knitting worsted or Germantown type yarn. Knitting tension should be tight enough to produce about 8 stitches per inch. If you do not obtain this gauge, then change to larger or smaller needles as your particular knitting tension requires. The size needle does not matter as long as the stitch gauge attained is correct. The above applies where it is desired to make a large size stocking about 21 inches long and 5½ inches wide at the top. If a larger or smaller stocking is desired use larger or smaller needles to obtain the gauge desired. Knitting 7 stitches per inch will produce a larger 23-inch stocking; 9 stitches per inch will make the stocking only about 19 inches long. Use Angora yarn for Santa s beard, and for the fur trim on his cap and suit. The 100% French Angora is recommended since it is the fuzziest. You may also wish to knit the white part of cuff and the white trim on the foot in Angora, as shown on stocking illustrated; or use plain white yarn. Other unusual effects include the carrying of a thread of tinsel with the green yarn when knitting the tree, sewing sequins or beads on the tree as ornaments, etc. Rhinestones make a nice trim for Santa's belt buckle, and perhaps a large one for a star at top of tree. Note that Santa's eyes, nose and mouth are represented by half-squares, appropriately colored, to form finer detail in the design. These divided squares are thus to be purled back in a color different from that of the knit part of the row. DIRECTIONS (Basic instructions for beginners on the manner of casting-on, how to knit, purl, decrease, etc., cannot readily be given here. These details are usually obtainable free, from your yarn shop.) MATERIALS (Note: Different brands of yarn vary in yardage. The following quantities per stocking, are approximate only.) Use 4-ply Germantown type yarn or knitting worsted 2½ oz. red, ½ oz. green, 3 yds. beige or ruddy pink for Santa's face and mittens, 4 yds. black for belt and boots, ½ oz. white. If Angora is used for Santa's beard and trim on his suit, approx. 28 yds. required (about one 10 gram ball). A second ball of Angora will be necessary for cuff and white trim on foot. Use a pair of single pointed needles for

3 the pattern. 1 set of double pointed sock needles will be necessary for the foot. Size No. 3 needles are recommended. Note that this stocking could be knit in basic color white instead of red if desired, then using red for stripes in cuff and foot. This would emphasize Santa's red suit. A green stripe can be added in center of white part of cuff if desired, to thus match stripes in foot. IMPORTANT (Handling Yarn) Use BOBBINS to carry your yarn in small quantities of each color. These will dangle clear of your work, avoiding entanglement. For certain small areas of color involving only a few stitches, you may prefer to merely use SHORT STRANDS of yarn, 12 to 15 inches long, dangling free, instead of bothering to wind separate bobbins. RECOMMENDATION Make free use of additional bobbins or short strands as new color groups are encountered. A given strand will often be used over again for stitches in the same color group in the following rows, so be sure it is started long enough for the color group it is to handle. CAUTION It is not desirable to carry one color yarn across the wrong side of another color, to reach stitches of the same color farther along the row. This would save extra strands of yarn, but in so doing the tension variation is likely to cause distortion of the stitches and thus spoil the clarity of the design. In some cases this carryover of yarn can be accomplished satisfactorily across only one or two stitches of another color, where design detail is not too critical. Some experienced knitters can carry yarn across even more than 2 stitches and avoid a loose loop on inside of stocking by twisting the yarn carried with the yarn being worked, but the danger of design distortion must be considered. You will have a more beautiful finished article if separate strands are used freely. The only inconvenience is a few more yarn ends to take care of in finishing inside of stocking. RECOMMENDATION ON BOBBINS FOR THIS PATTERN Use separate bobbins of red for areas on each side of central figure of Santa and tree; additional red bobbins for areas in Santa's suit. Use a separate bobbin of green for tree down each side; break off and restart the bobbin of yarn as necessary where green branches protrude into red background. Use separate short strands for each letter in "MERRY CHRISTMAS" and in other small areas of green. Pink and black may be used as short strands but may be more convenient on bobbins. White or Angora should be carried on a bobbin. Total of 8 bobbins will be found convenient (4 red, 2 green, 1 white or Angora, 1 black) plus short strands. CHOICE OF NAME Knit your choice of name and year on stocking if you wish. Simply fill in squares in the 5 rows (as outlined) to spell the name desired. The method of forming letters and numbers not already shown on the pattern, is indicated at the bottom of this sheet. You will then need to count and number the stitch groups in this area, or otherwise count squares while knitting this part. If you prefer to knit the name in the white cuff, make this white part 5 rows wide instead of 4, and graph in the desired letters. This area will accommodate a long name, or the words "Merry Christmas" could be pieced here instead of in the position shown. LEG PATTERN This part of the stocking is knitted in a flat piece, to be folded and sewed together up the back when completed. First cast on 90 stitches of red and purl back to beginning, making first row of pattern. Then knit a second row of red and purl it back, then 4 rows of white or Angora, purling each row back before knitting next row. Now start pattern proper on 7th row knitting as follows: 37 red, 3 green, 4 red, 1 green, 45 red. These numbers are indicated on the graph to save counting squares. In

4 changing colors always twist yarns around each other once to avoid leaving a hole. After knitting row number 7 in the colors indicated, turn end purl back ON THIS SAME ROW using the same colors in the same places. Now knit row #8 in colors indicated: 20 red, 1 green etc. to end of row and purl back in same colors as before. (NOTE: If you have inserted your choice of name, you will begin knitting stitch sequences accordingly (letters in green or white) to form the tops of the letters in this row). After purling back, knit the next row and continue in this manner for 64 rows using the color sequences, as shown with numbered stitch count, on the graph. See below regarding "side decreases," and "purl-back variations." SIDE DECREASES Beginning at row No. 19 and every 5th row thereafter, you will note that the total number of stitches decreases by 2 (to shape stocking). This is done by knitting 2 stitches together at the beginning of the row, and again at the end of the row, for these rows (Nos. 19, 24, 29 etc.) only. Decrease on knitted part of row only, not when purling. PURL BACK VARIATIONS You will note that on rows 23, 24, and 26, in doing Santa's eyes, nose and mouth, the stitches are purled back in a different color to form finer detail in the design. Thus on row #23 when you come to Santa's face, knit 1 pink, then 2 green (divided squares), 2 pink, 2 green (divided squares), and 1 pink etc. When purling back, purl 1 pink, 2 pink (divided squares), 2 pink, 2 pink (divided squares), 1 pink (Actually purling 8 pink solid across). Similarly handle stitches for nose and mouth on rows 24 and 26. This applies to these few squares only; all others are purled back in same color as knit. INSTEP After completing 64 rows the work is reduced to 72 stitches. Divide the 72 stitches, taking 18 off each end, place on separate needles or stitch holders to work later (will be the heel). Now continue pattern down instep of the stocking using the 36 center stitches. First row is 2 red, 6 black etc. Continue for 8 rows to end of pattern. Now discontinue work on this part of stocking and knit the heel. HEEL Place the 2 groups of 18 stitches previously divided from the instep pattern, on one needle. This folds the main pattern or leg of stocking into position for sewing up the back later. Now knit across this part and purl back in successive rows, as before, for 3 inches. On the last purl row, purl 20 stitches, then purl 2 together, purl 1 and turn work. Then: Knit back 6, knit 2 together, knit 1, turn. Purl back 7, purl 2 together, purl 1, turn. Knit back 8, knit 2 together, knit 1, turn. Purl back 9, etc. Knit back 10, etc. Etc. Continue in this manner, advancing the number of stitches worked at each end in this order, and thus making rounded bottom of heel, until all stitches are used, work then being all on one needle across bottom of heel. Now pick up stitches along the forward edges of the heel thus knitted, and add to the work in progress. About 28 or 30 stitches should be picked up on each side of the 3- inch long heel, and all of these heel stitches should be evenly divided on 2 needles. Now proceed to knit a row, purl a row,

5 alternately, and decrease 1 stitch on each side of the foot ON EACH KNIT ROW AND ON EACH PURL ROW to form ankle gusset. When work evens up with instep pattern previously completed, join all work together on 3 needles, keeping the 36 instep stitches on the one needle, other stitches evenly divided on the 2 underfoot needles. Now use a 4th working needle and continue with plain knitting round and round, and also continue to decrease the one stitch on each side of the foot ON EVERY ROW (on underfoot needles) until only 18 stitches remain on each underfoot needle. At this point knit the stripes in the foot (without any further decreasing). Knit 4 rows of white (these are now single knit rows), 4 rows green, 4 rows white. Then continue plain knitting in red until foot is 3 inches long measured from back of heel. TOE Now start decreasing to shape toe, as follows: Decrease 4 stitches on the next row, these being the end stitches on the instep needle, and the stitches next to these, one on each underfoot needle. Knit 4 rows plain then 1 row decreasing 4 stitches as before, 3 rows plain, 1 decreasing, 3 plain, 1 decreasing, 2 plain, 1 decreasing, 2 plain, 1 decreasing, 1 plain, 1 decreasing, then decrease every row until only 16 stitches remain (8 on instep needle and 4 on each underfoot needle). The shift to white yarn for the toe may be carried out at any point, or the entire foot may be made red. We suggest shifting to the white at the point of reaching the above sequence of 2 rows plain, 1 decreasing etc., to achieve the effect indicated in the stocking illustrated. Weave toe as follows: Place yarn in a tapestry needle and, with the yarn coming from the back of the knitting needle, put it in first stitch of front (instep) needle as if to knit and slip it off. Then put it in the next stitch of front needle as if to purl and leave it on. Go to back (underfoot) needle and insert as if to purl and take it off then to next stitch of back needle as if to knit and leave it on. This designation may assist: Front needle K off P on Back needle P off K on Repeat thus to the end of the 8 stitches on each needle. FINISH Sew stocking up the back, using corresponding color of yarn and tapestry needle. Sew foot up each side where instep pattern was knitted separately from lower foot in that area. Finish inside of stocking by weaving yarn ends into nearby seams, trimming ends etc. Block stocking by dampening lightly and laying out on a flat surface to dry (or steam press). Decorate stocking to suit your fancy. Stocking shown has jingle bells attached to yarn streamers, which are fastened to rear of cuffs. You may like a jingle bell attached to toe, or perhaps one attached to Santa's cap. These are noisier if they dangle a bit, so attach with a loop of single crochet of about 8 stitches, or sew on stocking direct. Sew a piece of bias tape on inside of cuff near top of finished stocking. This will carry the load of the filled stocking, preventing excessive stretch of the knitting by any heavy articles. GENERAL DIRECTIONS

6 Each square equals one stitch, knitted and/or purled. Sequences of stitches in particular colors to form a pattern are shown by numbers on the specific pattern graphs. This saves counting squares. The number of rows and number of stitches in each depend on the symmetry of the pattern design, also on the size and shape of the stocking desired. Size and dimensions are indicated in each particular pattern. Each row is knitted and purled back in the same color, except where otherwise indicated to form finer detail in the design. In which case the purled-back row may vary somewhat as shown in the pattern. Heel, bottom of foot, and toe are knitted in the manner of a plain stocking or sock. Where the instep is a plain color, and the same color as the foot this part of the stocking may be knitted round and round at in a plain sock.

7 Christmas Patterns