Part No Issued: Aug Model Instruction Manual (13 pages including cover)

Size: px

Start display at page:

Download "Part No Issued: Aug Model Instruction Manual (13 pages including cover)"

Ann Welch
7 years ago
Views:

1 Part No Issued: Aug 2011 Model Instruction Manual (13 pages including cover)

2 SAFETY PRECAUTIONS 2

3 FORWARD This manual covers the model # 5301 DUALNACHO CHEESE & CHILI DISPENSER. INSTALLATION CHECKING SHIPMENT Unpack the shipping carton and check thoroughly for any damage which may have occurred in transit. Any claims should be filed immediately with the transportation company. ELECTRICAL REQUIREMENTS Voltage for your warmer is 120 Volt, 60 Cycle, single phase. The 5301 BAG CHEESE DISPENSER will draw a maximum of 6.3 amps. Your electrician must furnish sufficient current for the proper operation of your machine. The on/off switch is located on the bottom back of the machine. NOTE: These instructions apply to all machines manufactured on or after August wiring. Failure to provide proper power supply (120v and 15 or 20 amp line) will void the warranty and can result in damage to the blower, heat element, lights, etc. 3

4 OPERATING INSTRUCTIONS INSTALLATION 1. Plug power cord into 120 v outlet 2. Pre-heat the unit. The unit itself will take approximately ONE hour to reach the operating temperature. Depending on the starting temperature of the bag of cheese or chili, they may take 2-4 hours to reach the serving temperature of 140F. a. Note: The control displays the lowest air temperature in the cabinet. It is factory set to 140F. The actual product temperature may be lower or higher than the 140F displayed temperature depending on how long it has been heated. b. The control has an indicator light labeled OUT (for output). When lit, the heaters are ON. The fans are always on. 3. Proper product temperature is between 140 F and 150 F. DISPENSING TEMPERATURE ADJUSTMENT 1. In normal operation, the Control displays the lowest air temperature in the cabinet. (see additional information above related to product temperatures ) 2. To adjust the set point from the factory setting of 140F to between 130F and 145F, follow these steps: a. Press SET b. Press Set o Action = enters the programming mode o Display = SP o Action/Display = shows the current set point temperature c. Press the UP or DOWN buttons to adjust the set point temperature d. Press Set o Action/Display = shows the new set point temperature o Action = Locks in the new set point temperature o Display = SP e. Press SET and DOWN buttons at the same time o Action = Exits the Programming Mode o Display = Current Air Temperature in Cabinet 4

5 140 OZ Bag of Cheese shown. 106 OZ Bag of Chili shown. Both are supplied with a tube & cap assembly for each bag. Dispose the used tube & cap with the empty bag. Install the tube & cap on the bag. o Pull the ring cap off the bag. o The product is still sealed in the bag and will not run out. o Thread the tube & cap onto the bag and tighten. This operation will pierce the bag seal. Rotate the knobs to open the pumps. 5

6 Installing the Cheese and Chili Bags Guide the tube down through the open pump. o Pull the tube and bag down until it looks like this picture. o The tray is removed in this picture. o Note: The tray is required to keep the product in the tubes at the proper temperature. Without the tray, the cheese and chili will not reach the correct temperatures. o Close the pump (as shown) being careful to not pinch the tube. Ready for use (tray in place) CAUTION Surfaces on the inside of this unit are HOT during operation, care should be taken when changing product or cleaning. 6

7 CARE AND CLEANING CLEANING INSTRUCTIONS The plastic exterior of the Cheese Dispenser is easy to keep clean. Usually a damp cloth will remove all dirt and grease spots. NEVER USE ABRASIVES. Turn power switch to the OFF position. Disconnect the unit from power source. Slide out the tray, and clean. Wipe exterior surface of unit. Wipe interior areas of the unit, confirm the unit is cool and unplugged. Replace tray. WARNING DO NOT IMMERSE UNIT IN WATER DO NOT HOSE DOWN UNIT OR THE COUNTER THE UNIT IS ON. KEEP AWAY FROM RUNNING WATER 7

8 MAINTENANCE INSTRUCTIONS ORDERING SPARE PARTS Parts Department Gold Medal Products Co Medallion Drive Cincinnati, Ohio or, place orders at: (513) (800) Fax: (513)

9 Pump Parts: (from left to right) P/N Thumb Screw P/N Washer P/N Pump Assembly (individual parts not available) P/N Sliding Pump Half P/N Pump Cam Lock P/N Slotted Shoulder Screw Pump Motors: (from left to right) P/N 36088R Clockwise viewed from door side (white fan) P/N Counter Clockwise viewed from door side (black fan) P/N Motor Mounting Screw Motors are 120v, 50/60HZ 9

10 PARTS LIST 5301 DUAL DISPENSER Heaters and Fans Remove the (4) screws and rotate plate down for access P/N v Heater P/N v Fan Notes: When these parts are ordered for service, they will have the lead wire and flag terminals attached. Fan leads are the same color and are not polarity sensitive. Control and Sensor P/N Heat Control (includes sensor shown in picture) P/N Sensor with lead only 10

11 PARTS LIST 5301 DUAL DISPENSER Other Service Parts (not shown) P/N Hinge Kit for Door (both hinges and mounting screws) P/N Slide Out Plastic Panel (picture on page 6 ) P/N Power lead cord P/N Strain Relief P/N Red dispense Switch (located in door), cheese and chili use the same switch) P/N Rubber foot (#8-32 threads) P/N On / Off Switch (located on rear panel) P/N Terminal Block (5 position) P/N Self Drilling and Tapping Cabinet Screw (qty = 36) Approx..16 dia x ½ long 11

12 12

13 WARRANTY WE WARRANT to the original purchaser the Gold Medal equipment sold by us to be free from defects in material or workmanship under normal use and service. Our obligation under this warranty shall be limited to the repair or replacement of any defective part for a period of six (6) months from the date of sale to the Original Purchaser with regard to labor and two (2) years with regard to parts and does not cover damage to the equipment caused by accident, alteration, improper use, voltage, abuse, or failure to follow instructions. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED, AND OF ALL OTHER OBLIGATIONS OR LIABILITIES ON OUR PART, INCLUDING THE IMPLIED WARRANTY OF MERCHANTIBILITY. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. We neither assume, nor authorize any other person to assume for us, any other obligation or liability in connection with the sale of said GOLD MEDAL equipment or any part thereof. The term Original Purchaser as used in this warranty shall be deemed to mean that person, firm, association, or corporation who was billed by the GOLD MEDAL PRODUCTS COMPANY, or their authorized distributor for the equipment. THIS WARRANTY HAS NO EFFECT AND IS VOID UNLESS THE ORIGINAL PURCHASER FIRST CALLS GOLD MEDAL PRODUCTS COMPANY AT TO DISCUSS WITH OUR SERVICE REPRESENTATIVE THE EQUIPMENT PROBLEM, AND, IF NECESSARY, FOR INSTRUCTIONS CONCERNING THE REPAIR OR REPLACEMENT OF PARTS. NOTE: This equipment is manufactured and sold for commercial use only. GOLD MEDAL PRODUCTS COMPANY Medallion Drive Cincinnati, Ohio USA Phone: Fax:

Instruction Manual. Fun Pop 8oz. Popper

Instruction Manual. Fun Pop 8oz. Popper Instruction Manual Fun Pop 8oz. Popper 0700 Medallion Drive, Cincinnati, Ohio 4524-4807 USA Part No. 5940 SAFETY PRECAUTIONS Page 2 INSTALLATION INSTRUCTIONS Inspection of Shipment Unpack all cartons and