EVERY LIFE HAS A PURPOSE

Transcription

1 Major Requirements of OSHA Respiratory Protection Standard 29 CFR Walter Fournet EVERY LIFE HAS A PURPOSE

2 29 CFR 1910 This standard applies to: General Industry (Part 1910), Shipyards (Part 1915), Marine Terminals (Part 1917), Longshoring (Part 1918), and Construction (Part 1926).

3 Organization of Standard (a) Permissible practice (b) Definitions (c) Respirator program (d) Selection of respirators (e) Medical evaluation (f) Fit testing (g) Use of respirators (h) Maintenance and care (i) Breathing air quality and use (j) Identification of filters, cartridges, and canisters (k) Training and information (l) Program evaluation (m) Recordkeeping

4 Permissible Practice (a) (1) The primary means to control occupational diseases caused by breathing contaminated air is through the use of feasible engineering controls, such as enclosures, confinement of operations, ventilation, or substitution of less toxic materials. When effective engineering controls are not feasible, or while they are being instituted, appropriate respirators shall be used pursuant to this standard.

5 Permissible Practice (a) (2) Employer shall provide respirators, when necessary to protect the health of the employee. The employer shall provide the respirators which are applicable and suitable for the purpose intended.

6 Definitions (b) This section includes definitions of important terms Air purifying, Assigned protection factor (APF), Air supplied respirator, Canister or cartridge, Demand respirator, Emergency situation, Employee exposure, Endo of life service indicator (ELSI), Escape only, Filter or air purifying element, Filtering facepiece, Fit factor, Fit test, Helmet, Hood, Interior structural fire fighting, Loose fitting facepiece, Maximum use concentration

7 Respiratory Protection Program (c) (1) Must develop a written program with worksitespecific procedures when respirators are necessary or required by the employer Must update program as necessary to reflect changes in workplace conditions that affect respirator use

8 Respiratory Protection Program (c) (3) The employer shall designate a program administrator who is qualified by appropriate training or experience to administer or oversee the program and conduct the required program evaluations for effectiveness. (4)The employer shall provide respirators, training, and medical evaluations at no cost to the employee. Note: OSHA has prepared a Small Entity Compliance Guide that contains criteria for selection of a program administrator and a sample program.

9 Selection of Respirators (d) (1) General requirements (i) Employer must select and provide an appropriate respirator based on the respiratory hazards to which the worker is exposed and workplace and user factors that affect respirator performance and reliability. (ii) Select a NIOSH-certified respirator that shall be used in compliance with the conditions of its certification. (iii) Identify and evaluate the respiratory hazards in the workplace, including a reasonable estimate of employee exposures and identification of the contaminant s chemical state and physical form. Where exposure cannot be identified or reasonably estimated, the atmosphere shall be considered Immediately Dangerous to Life or Health (IDLH)

10 Selection of Respirators (d) (2) Respirators for IDLH atmospheres (i) (A) Full Facepiece Pressure Demand SCBA certified by NIOSH for a minimum service life of 30 minutes (i) (B) Combination Full Facepiece Pressure Demand SAR with Auxiliary Self-Contained Air Supply

11 Selection of Respirators (d) (2) Respirators for IDLH atmospheres (iii) All oxygen deficient atmospheres shall be considered IDLH» An atmosphere with an oxygen content below 19.5% by volume Exception: Employers may use any atmosphere-supplying respirator, provided they can demonstrate, under all foreseeable conditions, that oxygen levels in the work area can be maintained within the ranges specified in Table II (i.e., between 19.5% and a lower value that corresponds to an altitude-adjusted oxygen partial pressure equivalent to 16% oxygen at sea level).

12 Selection of Respirators (d) (3) Respirators for atmospheres that are not IDLH (i) (A) Assigned Protection Factors (APFs) Employers must use the APF s listed in Table 1 to select a respirator that meets or exceeds the required level of protection. When using a combination respirator (e.g., airline with an air-purifying filter), must ensure that the APF is appropriate to the mode of operation in which the respirator is being used.

13 TABLE 1 ASSIGNED PROTECTION FACTORS 5 Respirator Type 1, 2 Quarter Mask Half Mask Full Face Helmet/Hood Loose- Fitting Air Purifying PAPR , /1, SAR Demand Continuous Flow Pressure Demand/ other (+) pressure ,000 1, /1, SCBA Demand Pressure Demand/ other (+) pressure , ,

14 Selection of Respirators (d) May use respirators assigned for higher concentrations in lower concentrations or when required use is independent of concentration. These APF s are only effective when employer has a continuing, effective respirator program per This APF category includes filtering facepieces and elastomeric facepieces. Must have manufacturer test evidence to support an APF of 1,000 or else these respirators receive an APF of 25. These APFs do not apply to escape-only respirators. Escape respirators must conform to (d)(2)(ii) or OSHA s substance specific standards, if used with those substances.

15 Selection of Respirators (d) (3) (B) Maximum Use Concentration (1) The employer must select a respirator that maintains exposure to the hazardous substance, when measured outside the respirator, at or below the MUC. (2) Employers must not apply MUCs to conditions that are IDLH; instead must use respirators listed for IDLH conditions per paragraph. (3) When the calculated MUC exceeds the IDLH level for a hazardous substance, or the performance limits of the cartridge or canister, then employers must set the maximum MUC at that lower limit

16 Maximum Use Concentration Example What is the MUC for an employee wearing a halfmask air purifying respirator (APF=10) in an atmosphere of sulfur dioxide gas (PEL=5 ppm)? MUC = APF x OSHA Exposure Limit MUC = 10 x 5 ppm = 50 ppm Note that this calculated value does not exceed the IDLH level for sulfur dioxide (100 ppm), so that the MUC for this example would be 50 ppm.

17 Selection of Respirators (d) (3) Respirators for atmospheres that are not IDLH (ii) (3) The respirator selected shall be appropriate for the chemical state and physical form of the contaminant.

18 Selection of Respirators (d) (3) Respirators for atmospheres that are not IDLH (iii) For protection against gases and vapors, the employer shall provide: (A) An atmosphere supplying respirator (B) An air purifying respirator (1) Provided that the respirator is equipped with an end of service life indicator (ELSI) certified by NIOSH for the contaminant (2) If there is no ELSI appropriate for workplace conditions, the employer implements a change schedule for canisters and cartridges that will ensure they are changed before the end of their service life.

19 Selection of Respirators (d) (3) Respirators for atmospheres that are not IDLH (iv) For protection against particulates the employer shall provide: An atmosphere supplying respirator or An air purifying respirator equipped with a HEPA filter certified by NIOSH under 30 CFR Part II or with filters certified for particulates under 42 CFR Part 84 or An air purifying respirator equipped with any filter certified for particulates by NIOSH for contaminants consisting primarily of particles of at least 2 micrometers.

20 Medical Evaluation (e) (1) General. The employer must provide a medical evaluation to determine employees ability to use a respirator before fit testing and use. (2) Medical evaluation procedures. (i) The employer must identify a physician or other licensed health care professional (PLHCP) to perform medical evaluations using a medical questionnaire or an initial medical evaluation that obtains the same information.

21 Medical Evaluation (e) (6) Medical determination. (i) Must obtain a written recommendation regarding the employee s ability to use the respirator from the PLHCP. (7) Additional medical evaluations. (i) Employee reports medical signs or symptoms related to the ability to use a respirator. (ii) A PLHCP, program administrator, or supervisor recommends reevaluation. (iii) Information from the respiratory program indicates a need for reevaluation. (iv) A change occurs in workplace conditions that may increase the physiological burden on employee.

22 Fit Testing (f) (1) All employees using a negative or positive pressure tight fitting facepiece respirator must pass an appropriate qualitative fit test (QLFT) or quantitative fit test (QNFT). (2)Fit testing is required prior to initial use, whenever a different respirator facepiece is used and at least annually thereafter. (3) Additional fit test is required when the employee reports, or the employer, PLHCP, supervisor, or program administrator makes visual observations of changes in the employees physical condition that could affect respirator fit ( e.g., facial scarring, dental changes, cosmetic surgery or change in body weight).

23 Fit Testing (f) (5) The fit test shall be administered using an OSHA-accepted QLFT or QNFT protocol as contained in mandatory appendix A. QLFT Protocols: Isoamyl acetate Saccharin Bitrex Irritant smoke QNFT Protocols: Generated Aerosol (corn oil, salt, DEHP) Condensation Nuclei Counter (PortaCount) Controlled Negative Pressure (Dynatech FitTester 3000) Controlled Negative Pressure (CNP) REDON

24 Fit Testing (f) (6) QLFT may only be used to fit negative pressure air purifying respirators that must achieve a fit factor or 100 or less.

25 Fit Testing (f) (7) If the fit factor, as determined through an ASHA-accepted QNFT protocol is equal to or greater than 100 for tight fitting facepieces or greater than 500 for tight fitting full facepieces, the QNFT has passed with that respirator.

26 Fit Factor A quantitative estimate of the fit of a particular respirator to a specific individual, and typically estimates the ratio: Concentration of a substance in ambient air Concentration inside the respirator when worn

27 Use of respirators (g) (1) Facepiece seal protection (i) The employer shall not permit respirators with tight fitting facepieces to be worn by employees who have: (A) Facial hair that comes between the sealing surface of the facepiece and the face or that interferes with valve function. (B) Personal protective equipment shall be worn in such a manner that does not interfere with the seal of the facepiece to the face of the user.

28 Use of Respirators (g) (iii) Employees shall perform a user seal check each time they put on a tight-fitting respirator using the procedures in mandatory Appendix B- 1 or equally effective manufacturer s procedures.

29 Maintenance and Care of Respirators (h) (1) The employer shall ensure that the respirators are cleaned and disinfected using the procedures in Appendix B-2 or equally effective procedures recommended by the respirator manufacturer. (i) Respirators for the exclusive use of an employee shall be cleaned and disinfected as often as necessary to be maintained in a sanitary condition. (ii) Respirators issued to more than one employee shall be cleaned and disinfected before being worn by different individuals. (iii) Emergency use respirators shall be cleaned and disinfected after each use (iv) Respirators used in fit testing and training shall be cleaned and disinfected after each use

30 Breathing Air Quality and Use (i) (1) (ii)compressed breathing air must meet at least the requirements for Type 1 - Grade D breathing air described in ANSI/CGA G : Oxygen content (v/v) of % Hydrocarbon (condensed) content of 5 milligrams per cubic meter (mg/m 3 ) of air or less CO content of 10 parts per million (ppm) or less CO 2 content of 1,000 ppm or less Lack of noticeable odor

31 Identification of filters, cartridges and canisters (j) All filters, cartridges and canisters used in the workplace must be labeled and color coded with the NIOSH approval label and that the label is not removed and must remain legible.

32 Employers must provide effective training to employees who are required to use respirators. The training must be comprehensive, understandable and recur annually and more often if necessary. Training and Information (k)

33 Training and Information (k) (1) Employees who are required to use respirators must be trained such that they can demonstrate knowledge of at least: (i) why the respirator is necessary and how improper fit, use, or maintenance can compromise its protective effect (ii) limitations and capabilities of the respirator (iii) effective use in emergency situations (iv)how to inspect, put on and remove, use and check the seals (v) maintenance and storage (vi) recognition of medical signs and symptoms that may limit or prevent effective use (vii) general requirements of this standard

34 Training and Information (k) (5)Retraining is required annually, and when: (i) changes in the workplace or type of respirator render previous training obsolete (ii) there are inadequacies in the employee s knowledge or use (iii) any other situation arises in which retraining appears necessary

35 Program Evaluation (l) (1) Must conduct evaluations of the workplace as necessary to ensure effective implementation of the program (2) Must regularly consult employees required to use respirators to assess their views on program effectiveness and to identify and correct any problems factors to be assessed include, but are not limited to: (i) respirator fit (including effect on workplace performance) (ii) appropriate selection (iii) proper use (iv) proper maintenance

36 Recordkeeping (m) (1) Records of medical evaluations must be retained and made available per 29 CFR (2) A record of fit tests must be established and retained until the next fit test is administered (3) A written copy of the current program must be retained (4) Written materials required to be retained must be made available upon request to affected employees and OSHA