Radi-Fire. Wireless systems from Channel Safety Systems

Transcription

1 Radi-Fire Wireless systems from Channel Safety Systems

2 Radi-Fire Wireless systems Radi-Fire provides a complete fire detection system without the need for a cabled connection between the field devices and control panel. Based on well proven components the sensors, sounders, beacons and call points give Radi-Fire a highly reliable foundation into which the wireless technology has been integrated to provide a fully featured analogue addressable fire detection and alarm system powered by low cost AA batteries. The development of Radi-Fire has tracked the progress of the European standard EN54-25: Fire detection and fire alarm systems and components using radio links; all elements of this wireless system have been designed to conform fully with all aspects. Addressable 250 device system Range greater than 1Km in free air Low profile aesthetics European tones, fully synchronised Dual anti-tamper function Meets the requirements of EN54-25 Future expandable - voice / other system Typical Applications Radi-Fire is suitable for an array of applications, including the following; Schools Hospitals No go areas for cabling Temporary systems Building sites, Site-cabins Temporary structures Frequent re-configuration Flexible offices Small shops Display areas Difficult cable routes Areas with difficult or limited access Areas where disruption is unacceptable Control Panel Fully featured analogue addressable fire control panel with bi-directional communication to all devices and designed to comply with all aspects of European standards EN radio devices per panel 16 indicated detection zones Large LCD for clear indication of status and programming Comprehensive panel with input/output facilities Full bi-directional radio communication Full cause & effect programmability RS232 port (download upload facility) Fully networkable (up to 127 panels per network) Supply Batteries Technology Radio Frequency Radio Devices Outputs (wired) Displays 230Vac 50Hz (nom) 24V 4Ah Unique custom radio module 868Mhz Up to 250 detection and alarm devices per panel 2 x Sounders circuits (1.5A total load) Auxiliary relay (24V 1A max load) RS 232,485 serial port Back lit touch screen display (120mm x 90mm) 16 x Zonal LEDs 8 x System status LEDs IP30 4Kg without batteries, 9Kg with batteries Height 375mm Width 357mm Depth 95mm F/CHRFA/16Z F/CHRFA/16Z/NC Arials Dimensions Height 85mm Width 85mm 16 zone wireless fire alarm control panel includes 24v 4Ah battery and antennas Network card for 16 zone wireless fire alarm control panel 2 revision sales@channelsafety.co.uk

3 Multi Criteria Detector Radi-Fire detectors are based on multi-sensor technologies using combinations of optical smoke detection, both fixed temperature and rate of rise heat detection. These elements can be selected to provide optimum detection of all types of fire and operating conditions. Multi-sensor technology combining optical smoke detection and to configure heat detection (fixed, R-O-R and high temperature) First fix base Depth 78mm Diameter 114mm F/CHRFA/SHD Multi criteria detector complete with base 0.3Kg Multi Criteria Detector Sounder Indicator Radi-Fire detectors are based on multi-sensor technologies using combinations of optical smoke detection and both fixed temperature and rate of rise heat detection. These elements can be selected to provide optimum detection of all types of fire and operating conditions. Multi-sensor technology combining optical smoke detection and to configure heat detection (fixed, R-O-R and high temperature) First fix base Highly visible led alarm visual indicator Alarm sounder Depth 78mm Diameter 114mm F/CHRFA/SHD/WB/BN Multi criteria sounder indicator complete with base Sound Output 90dB(A) Tones 3 Light Output 1Cd Flash Rate 1Hz Volume Control By panel - 3 levels 0.3Kg 3 revision sales@channelsafety.co.uk

4 Manual Call Point Radi-Fire Manual Call Points share all the features of the Universal CX on which they are based. In addition a tamper switch is provided so that an alarm is transmitted to the Radi-Fire Control Panel if the call point is dismantled or removed. Reassurance LED Glass or plastic re-settable element (both provided) Height 87mm Width 87mm Depth 57mm Element Type Glass / Plastic (re-settable) Temperature -10 C to + 55 C IP24D 50g F/CHRFA/BG Break glass unit Open Area Sounder Indicator The Radi-Fire Open Area Sounder Indicator is based on the Symphoni AV to provide a combined audible and visual alarm to suit applications 100dB(A) sounder Integrated highly efficient LED indicator 3 volume settings Fully networkable (up to 127 panels per network) Depth 91mm Diameter 105mm Sound Output 100dB(A) Tones 3 Light Output 1Cd Flash Rate 1Hz Volume Control By panel - 3 levels 600g F/CHRFA/WB/BN Open area sounder indicator 4 revision sales@channelsafety.co.uk

5 I/O Module The input/output (I/O) module provides the facility to monitor 3 independent inputs for fault and fire as well as providing the facility to operate 3 volt free contacts for operating devices such as magnetic door holders, in areas where the installation of system wiring is not an option. The unit is fully monitored and controlled by Radi-Fire Control Panel. Both inputs and outputs are available from the same unit and may be operated. 3 inputs Duplex technology (2 way communication) 3 volt free outputs Height 225mm Width 180mm Depth 63mm F/CHRFA/IO Wireless fire alarm input/output module Radio Frequency 868MHz Radio Devices 28 Temperature - 10 C to +55 C 0.9Kg Signal Booster The Radi-Fire Signal Booster allows devices outside the range of the Radi-Fire control panel to be addressed, monitored and controlled by the panel. Each Radi-Fire Booster operates its own dedicated wireless system on a different system ID and frequency from the main control panel. Up to 8 boosters can be commissioned onto the Radi-Fire control panel. Fully addressable Duplex technology (2 way communication) Mains powered and battery backed Up to 8 boosters per control panel Up to 28 Radi-fire devices per booster Height 331mm Width 270mm Depth 90mm F/CHRFA/SB Wireless fire alarm signal booster includes 12V 4Ah battery Batteries Radio Frequency Radio Devices Vac 50Hz (nom) 12V 3.2Ah 868MHz 2.1Kg without batteries, 3.5Kg with batteries 5 revision sales@channelsafety.co.uk

6 USB Interface The analogue systems panel interface (USBINT2) is a universal serial bus converter that provides conversions from RS232 to USB, TTL to USB or TTL to RS232. These options provide the connectivity required between a PC and intelligent addressable control panels, wireless control panels, and wireless survey tools. Intelligent addressable control panel to PC site installer connection using the RS232 to USB configuration Wireless control panel to PC site installer connection using the RS232 to USB configuration Wireless control panel to PC wireless live monitor connection using the TTL to USB/RS232 configurations Wireless survey tool to PC survey tool connection using the TTL to USB/RS232 configurations Benefits Simple PC driver installation Simple DIP switch configuration F/CHRFA/CABLE USB interface cable Survey Kit The Radi-Fire wireless survey kit is an essential tool for evaluating a site s suitability for a Radi-Fire wireless system prior to installation. The Radi-Fire wireless survey tool achieves this by using a thorough scan (on all available frequencies) to detect any interference or other wireless systems close to the site, as well as a survey (on all available frequencies) to check the signal quality between the panel location and the desired location of each individual remote device. These results provide the unit with all the information it requires to calculate the optimum frequency for the site. This tool is also essential for establishing if the installation site requires any Radi-Fire wireless booster panels. Comes complete with 3 x Standard AA batteries Duplex technology (2 way communication) Simple menu driven Interface Site scan for detecting interference and other wireless systems Site survey for checking signal quality before system installation Survey analysis to identify the best frequency channel Device commissioning Database containing site, can site survey and provide commissioning data Upload/download database to/from a PC or Laptop Batteries Wireless Frequency Visual Audible Keyboard 3 x AA Lithium (4.5 V) 3000 mahr (min) 868 MHz Graphical LCD display, Green GO LED, Red NO GO LED Internal buzzer 5 button keyboard 0.35kg Height 176mm Width 100mm Depth 39mm F/CHRFA/SK Survey kit 6 revision sales@channelsafety.co.uk