Cirolus Installation Guide H7 Projector Angel Eye Conversion Headlights in Shelby Cobra Downloadable PDF:

Transcription

1 Cirolus Installation Guide H7 Projector Angel Eye Conversion Headlights in Shelby Cobra Downloadable PDF: Click Here White LED Angel Eyes GiSi Super Thin Ballast Xenon H.I.D. kit (6000k, 8000k) Located in: San Francisco, California DOT SAE Approved GiSi Digital Xenon HID system GiSi Digital Xenon HID H7 & Ballast (35w slim series) GiSi Digital Xenon HID H7 & Ballast (35w slim series) GiSi Digital Xenon HID Ballast (35w slim series) 1 of 6 2/13/08 10:56 AM

2 Plug & Play H4 wiring adapter Plug & Play H4 wiring adapter Plug & Play H4 wiring adapter OEM Stock Shelby headlight Remove OEM stock Shelby headlight OEM Stock Shelby headlight (removed) OEM Stock Shelby headlight black headlight bucket Clean opening after the work GiSi Digital Xenon HID H7 & Ballast (35w slim series) Circolus headlight flipped upside down 2 of 6 2/13/08 10:56 AM

3 Unpluck the red & black wires (connected to the base of the bulb prongs) Remove black rubber boot Remove the halogen H7 bulb GiSi Digital Xenon HID H7 bulbs (35w series) GiSi Digital Xenon HID H7 bulbs (35w series) Unscrew plastic bulb case Unscrew plastic bulb case Pull tails of bulb through the opening of the black rubber boot (inside to outside) Pull tails of bulb through the opening of the black rubber boot (inside to outside) Pull tails of bulb through the opening of the black rubber boot (inside to outside) Latch lock the bulb to the slot after HID bulb is properly seated Latch lock the bulb to the slot after HID bulb is properly seated Squeeze the bulb tail's pigtail's grommit through as well Snug the black rubber boot around bulb base perimeter 3 of 6 2/13/08 10:56 AM

4 Advised to electric tape rear of (around the rubber boot & around below section of angel eyes wires) Mount HID ballast on chasis behind bucket with enough slack to reach rear of Use t-taps to connect angel eyes Use t-taps to connect angel eyes t-tap to OEM parking lights wires t-tap to OEM parking lights wires t-tap to OEM parking lights wires Screw in inner OEM Shelby trim to bucket Screw in inner OEM Shelby trim to bucket Test Circolus LED angel eyes And install outside OEM Shelby headlight trim 4 of 6 2/13/08 10:56 AM

5 Test Circolus LED angel eyes And install outside OEM Shelby headlight trim Test Circolus LED angel eyes And install outside OEM Shelby headlight trim Just Circolus LED HID on VS. OEM Stock Shelby headlight on HID on VS. OEM Stock Shelby headlight on HID on VS. OEM Stock Shelby headlight on HID on & LED HID on & LED OEM Stock Shelby headlight on OEM Stock Shelby headlight (curved glass) headlight (flat headlight (flat Circolus LED angel eyes both sides on 5 of 6 2/13/08 10:56 AM

6 glass) glass) Circolus LED angel eyes both sides on Circolus LED angel eyes both sides on Circolus with HID on & LED angel eyes on HID on & LED HID on & LED HID on & LED s with HID produce a clearer sharper wider brighter focused output s with HID produce a clearer sharper wider brighter focused output s with HID show a vivid cut-off line s with HID show a vivid cut-off line s with HID show a vivid cut-off line info@norcalmr2.com Main Page Copyright, of 6 2/13/08 10:56 AM