Item tested : Tecsonic DAB518. Type of equipment : DAB & FM radio. Client : Post- og teletilsynet

Transcription

1 Test report no. : Item tested : Tecsonic DAB518 Type of equipment : DAB & FM radio Client : Post- og teletilsynet Nemko Comlab is granted accreditation by Norwegian Accreditation under registration number TEST 033 Measurement the receive sensitivity and consumed power Authorized by :... Geir Antonsen Technical Verificator Nemko Comlab authorises the above named company to reproduce this report provided it is reproduced in its entirety and for use by the company s employees only. Any reproduction of parts of this report requires approval in writing from Nemko Comlab. This test report applies only to the items and configurations tested. Nemko AS, Gaustadalléen 30, P.O.Box 73 Blindern, NO-0314 Oslo Norway T F Enterprise number NO Visiting address: Nemko Kjeller, Instituttveien 6, P.O.Box 96, NO-2027 Kjeller Norway T F

2 CONTENTS 1 GENERAL INFORMATION Tested by Client Information Factory (if other than client) TEST INFORMATION Tested Item Test Environment Normal test condition Test Period Test Engineer Test Equipment TEST REPORT SUMMARY General Test Summary Other comments TEST RESULTS Receiver sensitivity for DAB signal Consumed power operating with using 240VAC TEST SETUP Setup for receive sensitivity test Setup for consumed power test TEST EQUIPMENT USED Nemko AS, N-2027 Kjeller Page 2 (11)

3 1 GENERAL INFORMATION 1.1 Tested by Name : Address : Nemko A/S Nemko Kjeller Instituttveien 6, Box 96 N-2027 Kjeller, NORWAY Telephone : Fax : Number of Pages: 11 comlab@nemko.com 1.2 Client Information Name : Post- og teletilsynet. Address : Nygård 1, Postboks 93, N-4791 Lillesand Telephone : Fax : Project ref. no.: Contact: Name : Oddbjørn Skogstad Telephone : Factory (if other than client) Name : Tecsonic Address : / Telephone : / Nemko AS, N-2027 Kjeller Page 3 (11)

4 2 Test Information 2.1 Tested Item Name : Tecsonic DAB518 Model/version : DAB518 Serial number : Hardware identity and/or version: / Operating Modes : Operating mode Signal port : antenna Power Supply : input 230Vac / 50Hz, 20W Description of Tested Device(s) The tested EUT is a radio with FM ( MHz) and DAB ( MHz). 2.2 Test Environment Normal test condition Temperature: C Relative humidity: % Normal test voltage: 239, VAC The values are the limit registered during the test period. 2.3 Test Period Item received date: Test period: and Test Engineer Thanh Tran and G. Suhanthakumar 2.5 Test Equipment See list of test equipment in clause 6. Nemko AS, N-2027 Kjeller Page 4 (11)

5 3 TEST REPORT SUMMARY 3.1 General The tests were conducted on a sample of the equipment as clien s request. Pre-production Unit Production Unit THIS TEST REPORT APPLIES ONLY TO THE ITEM (S) TESTED. Deviations from, additions to, or exclusions from the test specifications are described in Summary of Test Data. TESTED BY : DATE: Thanh Tran, Test Engineer Nemko authorizes the above named company to reproduce this report provided it is reproduced in its entirety and for use by the company s employees only. Any reproduction of parts of this report requires approval in writing from Nemko. Any use which a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko accepts no responsibility for damages suffered by any third party as a result of decisions made or actions based on this report. This test report applies only to the items and configurations tested. Nemko AS, N-2027 Kjeller Page 5 (11)

6 3.2 Test Summary See test results in chapter Other comments EUT (Equipment Under Test): is a radio with FM and DAB signal. The EUT is only powered from AC voltage. Nemko AS, N-2027 Kjeller Page 6 (11)

7 4 Test Results 4.1 Receiver sensitivity for DAB signal The test is performed in a 3 meter semi anechoic chamber. Test signal: The 1kHz DAB signal from generator R&S SFE Broadcast Tester, on channel 12D ( MHz) with data rate 192kbit/s. EUT configuration during test: EUT was placed on an isopod table with a height of 150 cm with the front facing the transmitting antenna and turn around 360deg. See the pictures on chapter 5 for test setup. EUT mode during test: The EUT was tested in operating (receiving) mode. Performance: At the start a -30dBm DAB signal was sent from DAB-generator to the antenna placed 3m from EUT. The EUT receives test signal and play it on the EUT s speaker. The sound from EUT s speaker was picked up by a microphone and amplifier. This sound/signal was led out of the chamber and connected to an oscilloscope and speaker for monitoring. The level of DAB signal generator was then adjusted until click or disturbance on the audio was detected. This was then noted as the sensitivity level. Results: Receive sensitivity for Level (dbuv/m) DAB signal 24.4 Comment: The relationship between signal generator level and the field strength at the receiving antenna position was calibrated before the test. Nemko AS, N-2027 Kjeller Page 7 (11)

8 4.2 Consumed power operating with using 240VAC The test is performed in a acoustic chamber. Test signal: The 1kHz DAB signal from generator R&S SFE Broadcast Tester. EUT configuration during test: EUT was placed on a table with a height of 80 cm with the front facing the microphone and the distance is 30/40/50cm. Microphone 50cm 30cm EUT 40cm See the pictures on chapter 6 for test setup. EUT mode during test: The EUT was tested in receiving mode when the sound level measured 75dBspl at the position of microphone. Performance: The 1kHz/-30dBm DAB signal was sent from DAB-generator to the antenna placed 50cm above the EUT. The EUT receives test signal and play out on the EUT s speaker. The sound/signal from speaker will be recorded by a microphone and measure/adjust to 75dBspl by using volume control on the EUT. A power meter used to measure the power when the sound is 75dBspl. Results: Consumed power operating with Power (W) 240VAC (no AC/DC converter) 7.7 Comment: None. Nemko AS, N-2027 Kjeller Page 8 (11)

9 5 Test Setup 5.1 Setup for receive sensitivity test Nemko AS, N-2027 Kjeller Page 9 (11)

10 TEST REPORT 5.2 Setup for consumed power test Nemko AS, N-2027 Kjeller Page 10 (11)

11 6 Test Equipment Used To facilitate inclusion on each page of the test equipment used for related tests, each item of test equipment and ancillaries are identified (numbered) by the testhouse. No Instrument/Ancillary Type Manufacturer Ref. No. 1 Test fixture B&K 2 Measuring Amp. w/ 2636 B&K LT Microphone 4134 B&K LT Artificial Mouth 4227 B&K LT Acoustic microphone w/ Amp. Comlab 6 Acoustical Calibrator 4231 B&K LT Broadcast Tester SFE R&S S/N Digital Power Meter 2534 YOKOGAWA N DC Power Supply B32-10R OLTRONIX LR Antenna HL562 R&S LR Autoranging Combiscope PM3392A Philips LR Multimeter 8060A Fluke LT Multimeter 77 Fluke LT Spectrum Analyzer FSU R&S LR1504 Nemko AS, N-2027 Kjeller Page 11 (11)