Quebec Quebec Tel : Fax : MSDS: Sulfur Dioxide in Nitrogen Mixture PRODUCT INFORMATION

Transcription

1 Tel: Fax: Internet: support@megs.ca Montreal Ottawa St-Laurent Nepean Tel : Tel : Fax : Fax : Quebec Quebec Tel : Fax : MSDS: Sulfur Dioxide in Nitrogen Mixture PRODUCT INFORMATION PRODUCT: Sulfur Dioxide in Nitrogen TRADE NAME: None CHEMICAL NAME: Sulfur Dioxide in Nitrogen SYNONYMS: None FORMULA: SO 2 in N 2 CHEMICAL FAMILY: Gas Mixture SUPPLIER'S NAME: MEGS Inc. SUPPLIER'S ADDRESS: 2675 De Miniac Ville St-Laurent, Qc, H4S 1E5 EMERGENCY PHONE NUMBER: (514) MOLECULAR WEIGHT: PRODUCT USE: Various PRODUCT IDENTIFICATION UN1955, Compressed gas, toxic n.o.s. NUMBER: CHEMICAL ID Sulfur Dioxide Nitrogen HAZARDOUS INGREDIENTS CONCENTRATION 1% - 10% Balance CAS # LD(50) None None LC(50) Inhl-hmn 400 ppm/ 1 min None PHYSICAL DATA PHYSICAL STATE: Gas under pressure APPEARANCE: Colorless ODOR: Pungent and irritating ODOR THRESHOLD: 3 ppm for SO2 SPECIFIC GRAVITY (H 2 O = 1): See Relative Density (air =1)

2 VAPOR PRESSURE: Not applicable (gas) VAPOR DENSITY (air = 1): 15 C,101.3 kpa EVAPORATION RATE: Not applicable (gas) BOILING POINT: SO2 = -10 C ; N2 = C FREEZING POINT: SO2 = C ; N2 = C ph: Not applicable (gas) GAS DENSITY: C,101.3 kpa COEFFICIENT OF 15 C, Bunsen Coefficient DISTRIBUTION: N2 = ; SO2 = CONDITIONS OF FLAMMABILITY: FIRE OR EXPLOSION HAZARD MEANS OF EXTINCTION: FLASHPOINT AND METHOD OF DETERMINATION: UPPER EXPLOSION LIMIT (% BY VOL): LOWER EXPLOSION LIMIT (% BY VOL): AUTO-IGNITION TEMPERATURE: FLAMMABILITY CLASSIFICATION: HAZARDOUS COMBUSTION PRODUCTS: EXPLOSION DATA: SENSITIVITY TO STATIC DISCHARGE: None REACTIVITY DATA CHEMICAL STABILITY: Chemically stable, however reacts violently with water to produce toxic and corrosive fumes INCOMPATIBLE MATERIALS: Peroxides, chromates, bichromates, permanganates and other strong oxidizers CONDITIONS OF REACTIVITY: Below 60 C and in the presence of water forms sulfuric acid HAZARDOUS DECOMPOSITION Reacts with chlorates to form PRODUCTS: chlorine peroxide. Reaction becomes explosive as the temperature rises with the formation of chlorine. TOXICOLOGICAL PROPERTIES

3 ROUTES OF ENTRY: SKIN CONTACT: Corrosive and irritating to the skin and eyes. Symptoms depend on the concentration and duration of exposure and very from mild irritation to severe destruction of tissues. SKIN ABSORPTION: Unknown EYE: Eye contact results in pain, lachrymation, inflammation, swelling of tissue and possible destruction of the eye. INHALATION: Corrosive and irritating to the upper and lower respiratory tracts. The symptoms may include burning sensations, coughing, wheezing, laryngitis, shortness of breath, headache, nausea, and vomiting. If the sulfur dioxide penetrates the lower airway, it can produce bronchitis, chemical pneumonitis and pulmonary edema. Concentrations of 6-12 ppm can cause immediate irritation of the nose and throat. INGESTION: Unknown ACUTE OVER EXPOSURE EFFECTS: Exposure to atmospheres contaminated with sulfur dioxide is extremely irritating. Its odor and prompt irritant action provide a warning of exposure to toxic conditions. High concentrations are extremely destructive to tissues of the eyes and skin. Inhalation may have fatal consequences as a result of spasm, inflammation and edema of the larynx and bronchi, chemical pneumonitis and pulmonary edema. Exposure of the eyes to high concentrations may result in ulceration of the conjunctivae and cornea and destruction of all ocular tissues. Contact with the skin causes severe burns. Systemic toxicity due to sulfur dioxide is not known to occur. CHRONIC OVER EXPOSURE EFFECTS: Unknown EXPOSURE LIMITS: TWA (SO2) = 2 molar ppm; STEL = 5 molar ppm (ACGIH ) IRRITANCY OF PRODUCT: See Skin and Eye Contact, above SENSITIZATION TO MATERIAL: None known CARCINOGENICITY, REPRODUCTIVE EFFECTS: None known TERATOGENICITY, MUTAGENICITY: Sex chromosome loss, Drosophila melanogaster, oral 2000 umol/liter TOXICOLOGICALLY SYNERGISTIC PRODUCTS: None known

4 NOTE: NITROGEN HAS NO IRRITATING OR TOXIC EFFECTS PREVENTIVE MEASURES PERSONAL PROTECTIVE EQUIPMENT: Silicon or Butyl rubber gloves. Safety goggles or glasses, face shield. Safety shoes, safety shower and eyewash "fountain". SPECIFIC ENGINEERING CONTROLS: Hastelloy C and F, aluminum, and stainless steel 304, 316 may be used with sulfur dioxide mixtures. System should be designed to accomadate the pressures involved with the mixture. LEAK AND SPILL PROCEDURES: EVACUATE ALL PERSONNEL FROM AFFECTED AREA. Use appropriate protective equipment. If leak is in user's equipment, be certain to purge piping with an inert gas prior to attempting repairs. If leak is on container or container valve, contact the closest MEGS location. WASTE DISPOSAL: Do not attempt to dispose of waste or unused quantities. Return in the shipping container properly labeled, with any valve outlet plugs or caps secured and valve protection cap in place to MEGS for proper disposal. For emergency disposal, contact the closest MEGS location. HANDLING PROCEDURES AND EQUIPMENT: USE ONLY IN WELL- VENTILATED AREAS. Valve protection caps must remain in place unless container is secured with valve outlet piped to the point of use. Do not drag, slide or roll cylinders. Use a suitable hand truck for cylinder movement. Use a pressure reducing regulator when connecting to lower pressure piping or systems. Do not heat cylinder by any means to increase the discharge rate of product from the cylinder. Use a check valve or trap in the discharge line to prevent hazardous back flow into the cylinder. Close valve after each use and when empty. STORAGE REQUIREMENTS: Protect cylinders from physical damage. Store in cool, dry, well-ventilated area of non combustible construction away from heavily trafficked areas and emergency exits. Do not allow the temperature where cylinders are stored to exceed 52 C. Cylinders must be stored upright and firmly secured to prevent falling or being knocked over. Full and empty cylinders should be segregated. Use a "first in - first out" inventory system to prevent full cylinders being stored for excessive periods of time. TDG CLASSIFICATION: 2.3 WHMIS CLASSIFICATION: A, D1, E

5 SPECIAL SHIPPING INFORMATION: Always secure cylinders in an upright position before transporting them. NEVER transport cylinders in trunks of vehicles, enclosed vans, truck cabs or in passenger compartments. Transport cylinders secured in open flatbed or in open pick-up type vehicles. FIRST AID MEASURES SPECIFIC FIRST AID PROCEDURES: PROMPT MEDICAL ATTENTION IS MANDATORY IN ALL CASES OF OVEREXPOSURE TO SULFUR DIOXIDE. RESCUE PERSONNEL SHOULD BE EQUIPPED WITH SELF-CONTAINED BREATHING APPARATUS. INHALATION: Conscious persons should be assisted to an uncontaminated area and inhale fresh air. Unconscious persons should be moved to an uncontaminated area, given assisted resuscitation and supplemental oxygen. Keep the victim warm and quiet. Assure that mucous or vomited material does not obstruct the airway by positional drainage. The physician should be informed that the patient has inhaled acidic vapors. EYE CONTACT: PERSONS WITH POTENTIAL EXPOSURE TO SULFUR DIOXIDE SHOULD NOT WEAR CONTACT LENSES. SKIN CONTACT: Flush affected area with copious quantities of water. PREPARED BY: Safety Department DATE PREPARED: 08/27/1999 LAST REVISION DATE: 05/21/2002 PREPARATION INFORMATION THE INFORMATION, RECOMMENDATIONS AND DATA CONTAINED IN THIS DOCUMENT ARE INTENDED TO BE USED BY PROPERLY TRAINED AND QUALIFIED PERSONNEL ONLY AND AT THEIR SOLE RISKS AND DISCRETION. THE INFORMATION, RECOMMENDATIONS AND DATA HEREIN CONTAINED ARE DERIVED FROM SOURCES WHICH WE BELIEVE TO BE RELIABLE. HOWEVER, MEGS INC. MAKES NO REPRESENTATION AND GIVES NO WARRANTY OF ANY KIND WHATSOEVER WITH RESPECT TO THEIR ACCURACY OR COMPLETENESS AND ASSUMES NO LIABILITY FOR DAMAGES OR LOSS ARISING DIRECTLY OR INDIRECTLY FROM

6 THEIR USE, WHETHER PROPER OR IMPROPER.