62 Lembo 2-Ply Coater Laminator Embossing Line #1

Transcription

1 62 Lembo 2-Ply Coater Laminator Embossing Line #1 Used 62 Lembo 2-Ply Coater Laminator Embossing Line, equipped with 30 maximum diameter 2- position unwind (drop splice, 3 chucks on 1.5 steel shafts, driven pull roll with nip, web aligner, pre-heat roll), 36 maximum diameter 2-position unwind (drop splice, 3 chucks on 1.5 steel shafts, pull roll, web aligner, pre-heat roll), 8 pre-heat rolls with overhead IR heaters and exhaust hood with fan, 2-roll gravure coating station (6 gravure roll, 10 rubber roll, doctor blade, stainless steel coating pan), embossing section (one 12 diameter chilled embossing roll on machine included, 12 rubber-covered backing roll), 24 chill roll, pull roll, area for perforator (perforator not included), accumulator, score slitting section, 30 maximum diameter turret rewind (3 button-type air shafts). Previously running thermal drape material. Maximum mechanical speed: 150 FPM. 74 Lembo 2-Ply Coater Laminator Embossing Line #2 Used 74 Lembo 2-Ply Coater Laminator Embossing Line, equipped with a 30 maximum diameter 2- position unwind (drop splice, 3 button-type air shafts, web aligner), accumulator, pre-heat roll, slat spreader roll, gravure coating section (6 gravure roll, 14 rubber-covered roll, can be by-passed), 40 diameter 2-position unwind (drop splice, 3 chucks on 1.5 steel shafts), 2-roll gravure coating station (6 gravure roll, 10 rubber-covered roll, doctor blade, stainless steel coating pan), laminate at slat spreader roll, 7-roll preheat section with six (6) heated 8 rolls, IR heaters and exhaust hood with fan above heated rolls, embossing section (one 12 diameter chilled embossing roll on machine included, 12 rubber-covered backing roll), 14 chill roll, needle perforator, accumulator, web aligner, score slitting section, spreader roll, 30 maximum diameter turret rewind (two 3 button-type air shafts). Maximum mechanical speed: 150 FPM. 74 Lembo 4-Ply Coater Laminator Embossing Line #3 Used 74 Lembo 4-Ply Coater Laminator Embossing Line, equipped with two (2) 30 maximum diameter 2-position unwinds (drop splice, 3 button-type air shafts/3 chucks on 1.5 steel shafts), slat spreader roll, gravure coating station (6 gravure roll, 8 rubber-covered roll, doctor blade, stainless steel coating pan), two (2) slat spreader rolls, pre-heat roll, two (2) 36 high pressure steam cans ( F), 8 nip roll, 8 heated roll, 3 heated roll on each steam can, two (2) 30 maximum diameter 2-position unwinds (drop splice, 3 button-type air shafts/3 chucks on 1.5 steel shafts), slat spreader roll, gravure coating station (6 gravure roll, 8 rubber-covered roll, doctor blade, stainless steel coating pan), two (2) slat spreader rolls, pre-heat roll, embossing section (one 12 diameter chilled embossing roll on machine included, 10 rubber-covered backing roll), exhaust hood with fan, 8 chill roll, three (3) 24 chill rolls, accumulator, web aligner, slat spreader roll, score slitting section, steel spreader roll, 40 maximum diameter turret rewind (3 button-type air shafts, driven pull roll), 3HP main drive, two (2) 2HP rewind drives. Maximum mechanical speed: 150

2 FPM. Great for heat seal applications. Previously producing projector screen material and military camouflage. 74 Lembo 3-Ply Coater Laminator Embossing Line #4 Used 74 Lembo 3-Ply Coater Laminator Embossing Line, equipped with two (2) 40 maximum diameter 2-position unwinds (drop splice, 3 chucks on 1.5 steel shafts), pre-heat roll, two (2) slat spreader rolls, gravure coating station (6 gravure roll, 8 rubber-covered backup roll, doctor blade, web aligner, slat spreader roll, 8 rubber-covered nip roll on 36 steam can, slat spreader, 40 maximum diameter 2-position unwind (drop splice, 3 chucks on 1.5 steel shafts), pre-heat roll, slat spreader roll, gravure coating station (6 gravure roll, 8 rubber-covered backup roll, doctor blade, web aligner, slat spreader roll, 8 rubber-covered nip roll on 36 steam can, slat spreader, two (2) 6 heated rolls after each 36 steam can, embossing section (one 12 diameter chilled embossing roll on machine included, 10 rubber-covered backing roll), two (2) 24 chill rolls, accumulator, web aligner, score slitting section, slat spreader roll, 24 maximum diameter turret rewind (3 button-type air shafts), 5 HP AC drive and motor for embosser. Maximum mechanical speed: Color Lembo Rotogravure Press Used 86 2-color Lembo rotogravure printing press equipped with 40 maximum diameter 2-position unwind with drop splicer, two (2) 2 diameter steel shafts with 3 chucks, driven pre-heat pull roll section with slat spreader roll, two (2) gravure press decks, between deck and overhead dryer operating at room air temperature, chill roll, web aligner, Oxy Dry system, accumulator, score slitting, 24 maximum diameter turret rewind with 3 diameter button-type air shafts, drives and controls Color Lembo Rotogravure Press Used 72 4-color Lembo rotogravure printing press equipped with 40 maximum diameter 2-position unwind with drop splicer, two (2) 3 diameter button-type air shafts, driven pre-heat pull roll section with slat spreader roll, four (4) gravure press decks, between deck and overhead dryer operating at room air temperature, chill roll, web aligner, slat spreader roll, Oxy Dry system, accumulator, score slitting, 24 maximum diameter turret rewind, drives and controls.

3 96 6-Color Lembo Rotogravure Press Used 96 6-Color Lembo rotogravure printing press equipped with 40 maximum diameter 2-position unwind with drop splicer, two (2) 2 diameter steel shafts with 3 chucks, slat spreader roll, six (6) gravure press decks, between deck and overhead dryer operating at room air temperature, chill roll, web aligner, slat spreader roll, Oxy Dry system, accumulator, score slitting, 24 maximum diameter turret rewind with 3 diameter button-type air shafts, drives and controls. MMT Environmental Services Sigma Series Model Recuperative Thermal Oxidizer Used MMT Environmental services Sigma Series Model recuperative thermal oxidizer designed for 15,000 SCFM air flow capacity operating at % VOC destruction F inlet temperature, 600 F outlet temperature, recuperative type heat exchanger, 70% nominal heat recovery effectiveness, 81% solvent concentration, 0.7 second minimum residence time in combustion chamber, 7.7 MBTU/hour natural gas burner design capacity, 26:1 burner turndown, 5:1 system flow, 100 HP fan, fan damper system flow control, 15 minute start up time. The RTO consists of a fume/air pre-heater, combustion chamber, burner section, supply air fan, expansion joints and controls. 460/3/60 power. Fiber Controls Flock Feed Control System Used Fiber Controls flock feed system equipped with five (5) bale openers (three units require repair), conveyor, two (2) beaters, air conveying system (4 HP fan). Wise-Fehrer Needle Punch Line #1 Used Wise-Fehrer Needle Punch Line equipped with Wise hopper, feed section, 60 garnets with 30 diameter roll, top lapper, 140 bottom lapper, 30 diameter scrim unwind under needle punch, Fehrer needle punch, magnet, score slitting, 32 diameter two drum winder, 156 wide x 12 diameter winding drums, Reliance drives and controls, 440V/3/60. Wise-Proctor Needle Punch Line #2 Used Wise-Proctor Needle Punch Line equipped with Wise hopper, feed section, 60 garnets with 30 diameter roll, top lapper, 128 bottom lapper, 30 diameter scrim unwind under needle punch, Proctor needle punch, magnet, score slitting, 32 diameter two drum winder, 124 wide x 15 diameter winding drums, Reliance drives and controls, 440V/3/60.

4 2003 Generac 40 KVA/40 KW Industrial Gas Generator Set New/Never Used Generac SG040 type EPA certified stationary emergency generator set rated for 40 KVA/40KW. Type Code: SG N18PDYYC. Propane/Natural Gas Vapor. New in 2003 never installed or used. Thermal Care PACS Ton Chiller Used Model PACS Ton capacity outdoor air-cooled central chiller equipped with a Model PT1550 pump/reservoir system, two (2) refrigeration circuits, two (2) rotary screw compressors, copper tube condenser. 1,200 gallon working capacity. Chiller installed in 1997 and is currently operating. Rated at 221 amps Jeep Grand Cherokee Limited 4x4 Used 1996 Jeep Grand Cherokee Limited 4x4 with 85,777 miles. White with gold trim, Tan leather dual power heated seats, V8, 4-door, ABS brakes, power locks, power windows, power heated mirrors, cruise control, power steering, tilt wheel, privacy glass, roof rack, sun roof, alluminum wheels, AM/FM/CD/Cassette radio, anti-theft security system, tow package, and many other options. Tires like new, interior has some head liner that is sagging and loose. Body has no rust or dents. A beautiful, low mileage vehicle. VIN: 1J4EZ78Y4TC Caterpillar 216 Skid Steer Used 2003 Caterpillar Model 216 Skid Steer with very low hours (175), and equipped with 60 bucket, 60 snow blade, full cage cab, windshield wiper, joystick style controls. In Like New condition inside and out. Mint! Nissan 50 Enduro 5,000 lb. Lift Truck Used 5,000 lb. Nissan 50 Enduro lift truck, model KCPH02A25PU, propane powered, and equipped with 60 forks, Side Shift, 203 maximum lift height. Lift truck with low hours (432), in great shape driven in plant only. Crown 50TCTT-188 4,500 lb. Lift Truck

5 Used 4,500 lb. Crown model 50TCTT-188 lift truck, electric powered, and equipped with 54 forks, Side Shift, 188 maximum lift height. Lift truck is in very good shape driven in shop area only. Hours unknown.

6 Crown 40FCTT-188 4,500 lb. Lift Truck Used 4,500 lb. Crown model 40FCTT-188 lift truck, electric powered, and equipped with 54 forks, Side Shift, 188 maximum lift height. Lift truck is in very good shape driven in shop area only. Hours unknown. Clark Narrow Aisle 2,900 lb. Lift Truck Used 2,900 lb. Clark Narrow Aisle lift truck, model NS300-40, electric powered, and equipped with 60 forks, 230 maximum lift height. Lift truck is in very good shape driven in warehouse only. Hours unknown. Mitsubishi Narrow Aisle 3,600 lb. Lift Truck Used 3,600 lb. Mitsubishi Narrow Aisle lift truck, model 1ESR36, electric powered, and equipped with 60 forks, Side Shift, 226 maximum lift height. Lift truck well maintained driven in warehouse only. Hours unknown. Misubishi FGC25 5,000 lb. Lift Truck Used 5,000 lb. Mitsubishi lift truck, model NS300-40, cushion tires, propane powered, and equipped with 42 forks, side shift, triple mast. Lift truck is in good condition. Hours unknown. Simplicity 16HP Garden Tractor Used Simplicity Model HP Garden Tractor with 175 operating hours, and equipped with automatic traction control, full cab, high/low range, 46 snow blower attachment, 60 mower deck, wheel weights, counter rear weights, tire chains. This machine looks like if just came off the dealer floor. Taylor Dunn Personnel Carrier (2010) Used 2010 Taylor Dunn Model RO Electric Personnel Carrier. Electric (36V), Seats 4, Uni-Body 16 Ga. Construction. Only used by president when he was at the site. In Like New condition.

7 Gardner Denver Air Compressor (1991) Used Gardner Denver Model rated for 200 psi. 460 V. Unit provides plant-wide air supply and has been well maintained. Ingersoll-Rand 100 HP Air Compressor Used Indersall-Rand Model EP100ESP 100 HP air compressor rated for psi. Maximum discharge pressure: 128 psi. 230/460 V. Like New Condition. Ingersall-Rand Air Dryer (2005) Used Ingersall-Rand Model TS4A Compressed Air Dryer, rated for maximum air pressure of 150 psi. Air cooled, R404A refrigerant. Still under power. Used as a backup seldom in use. Like new condition. Crown 4,000 lb. Electric Pallet Jack Used Crown model 40GPW ,000 lb. capacity electric pallet jack, 24V.