MS900AC-B-LS User Information

Size: px

Start display at page:

Download "MS900AC-B-LS User Information"

Amelia Banks
8 years ago
Views:

1 MS900AC-B-LS User Information MS900-R-AC-B-LS systems equipped with MR900 Micro Receiver are Receive-Only. MS900-X-AC-B-LS systems equipped with MX900 Micro Transceiver will Send and Receive. The model MS900AC-B-LS is an AC powered Micro Receiver System designed to send and receive signaling data transmissions from Grace Industries telemetry products including SuperCell and TPASS. The MS900AC-B-LS is powered by a 120 VAC source with an internal 12VDC battery backup; it interfaces easily with existing alarm systems and is suitable for use in a fixed monitoring location.

The model MS900AC-B-LS is an AC powered Micro Receiver System designed to send and receive signaling data transmissions from Grace Industries

2 For fi xed location installation the MS900AC-B-LS must be mounted in an area where there is a clear unobstructed path to the environment where the Transmitting PASS (man-down-alarm) or SuperCell (man-down alarm) may be used. A typical location for the MS900AC-B-LS would be near an unobstructed offi ce window or mounted just outside the offi ce. The MS900AC-B-LS should also be located as far away as possible from other radio equipment antennas to minimize any interference. This includes cell phone and other 2-way radio equipment antennas. The power consumption of the MS900 is less than 1Amp at 125VAC. A System Check of the MS900AC-B-LS can be done by viewing the Receive LED located on the bottom surface of the MS900. When a SuperCELL or TPASS is turned On, Off or by activating the Alarm, the radio signal will cause the Red Receive LED to fl ash several times - indicating signals are successfully being received by the MS900. When the unit is plugged in to AC Power, the Amber AC Power Indicator glows - indicating the system has power and is ready for operation. With loss of power, the Amber AC Power Indicator will not glow. The Backup-Battery System is automatically activated, keeping the MS900 ON and ready for operation. If MS900 has the Out-of-Range option, the Green Transmit LED will fl ash when MS900 is transmitting. IMPORTANT: Always test MS900AC-B-LS and man-down alarms in area of planned use prior to implementation. MR900 or MX900 Connector for Optional Phone Dialer Receive LED (Red) 12 VDC Battery Backup Terminal Blocks Conduit Connector Transmit LED (Green) (MS900-X models only) Power LED (Amber) Inside View of MS900AC-B-LS (Shown with Optional Phone Dialer Connection) Page 2 MS900AC-B-LS 0714

The MS900AC-B-LS should also be located as far away as possible from other radio equipment antennas to minimize any interference. This includes cell phone and other 2-way radio equipment antennas.

3 Terminal Block Labeling and Configuration A. MICRO (Reciever/Transceiver) Input/Output Terminals: Ground (GND) RX - Receive TX - Transmit (Only used with MX900 Transceiver) B. Power Terminals: Line Neutral GND C. Relay Terminals: Normally Open Common Normally Closed. Relay Terminals Tx: Transmit (MX900 Only) Rx: Receive Ground Neutral GND to 12V Circuit Line Power Terminals MICRO Input/Output Terminals Additional Notes: Connect the AC Power cable to the Line and Neutral positions. When setting case lid in place - make sure the light siren cable is NOT pinched. To seal from intrusion of contaminants, secure the case lid by tightening all four (4) lid bolts until snug. Once Installation and Field-Testing is complete, the MS900AC-B-LS is ready for use. Page 3 MS900AC-B-LS 0714

Relay Terminals Tx: Transmit (MX900 Only) Rx: Receive Ground Neutral GND to 12V Circuit Line Power Terminals MICRO Input/Output Terminals Additional Notes: Connect the AC Power cable to the Line

4 Stobe / Siren Settings ON Horn Dipswitch OFF Pattern 1 ON and 2 OFF = Non Temporal 1 OFF and 2 OFF = Temporal 1 ON and 2 ON = March Time Tone 3 ON and 4 ON = 2400 Hz 3 ON and 4 OFF = Electromechanical 3 OFF and 4 OFF = Chime 3 OFF and 4 ON = Broadband Volume 5 ON and 6 ON = High 5 ON and 6 OFF = Mid 5 OFF and 6 OFF = Low 7 ON and 8 ON = Horn ON 7 OFF and 8 OFF = Horn OFF Page 4 MS900AC-B-LS 0714

Electromechanical 3 OFF and 4 OFF = Chime 3 OFF and 4 ON = Broadband Volume 5 ON and 6 ON = High 5 ON

5 MS900-AC-B-LS AC Powered Micro Receiver System Specifications (With Battery Backup) Case: Rugged fi berglass Dimensions: 6-1/2 wide by 15 high by 6-1/2 deep Weight: 10 lb. Power Input Requirement: 120 VAC, 60 Hz Single Phase 1Amp Battery: 12 VDC, 2.9 Amp. Hr. Frequency Range: MHz (frequency hopping spread spectrum) For Use With: Grace Industries SuperCells, LTX200, TPASS-2 and TPASS-3 Personal Safety and monitoring products. Relay Closure: Contact ratings 30VDC, 125VAC. Relay Closure remains activated for approximately 20 seconds after last alarm message is received. Data Output: RS-232 type, 9600-bps ASCII encoded numeric data General Warranty Information Grace Industries, Inc. warrants Grace Products to be free from defects in workmanship and materials for a period of one year from the date of purchase. This warranty is valid only when the returned products are accompanied by a sales slip or other proof of purchase that states the date and location of purchase. Grace Industries, Inc. will not repair or replace any merchandise under warranty which has been damaged because of accident, misuse or abuse of the products while in possession or control of the consumer. This warranty is void if any attempt to repair or replace parts was made or attempted by other than qualifi ed Grace Industry s Inc. personnel. This warranty is void if any of the sealed compartments are opened or tampered with. Before sending product to Grace for repair, call for Return Material Authorization or RMA #. Please reference RMA# in shipping documents for tracking purposes. Send all repair products, prepaid and accompanied by proof of purchase to: Grace Industries, Inc., Repair Division, 305 Bend Hill Road, Fredonia, PA Grace Industries, Inc. shall not be liable for any direct, incidental or other consequential loss or damage arising out of the failure of the device to operate. End-user or customer is responsible for return shipping/freight charges. The sole and exclusive remedy under all guarantees or warranties, expressed or implied, is strictly limited to repair or replacement as herein provided. All implied warranties, including but not limited to, warranties of fi tness and merchantability, are hereby limited in duration to a period ending one (1) year from the date of purchase. The warranty and liability set forth in the prior paragraphs are in lieu of all other warranties, expressed or implied, in law or in fact, including implied warranties of merchantability and fi tness for a particular purpose. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. Technical assistance is available by contacting Grace Industries, Inc. at Product issues may be reported at any time to Grace Industries, Inc. at Page 5 MS900AC-B-LS 0714

Frequency Range: 907-922 MHz (frequency hopping spread spectrum) For Use With: Grace Industries SuperCells, LTX200, TPASS-2 and TPASS-3 Personal Safety and monitoring products.

6 MS900AC-B-LS Mounting Assembly - Pole Mounted with W Brackets - Locking Washer Bracket Washer U-Bolt and Bracket Assembly Bolt Pole MS900AC-B-LS Top View Pole Non-Metallic U-Bolt and Bracket Assembly MS900AC-B-LS Side View Improper Installation May Degrade Performance Page 6 MS900AC-B-LS 0714

Top View Pole Non-Metallic U-Bolt and Bracket Assembly MS900AC-B-LS Side

7 OPTIONAL EQUIPMENT - Automatic Phone Dialer - MS900 with phone dialer has 4 pin connector to supply relay contact trigger and power to the external phone dialer. CAUTION: To avoid damaging mating pins - carefully match up connector keyways when attaching phone dialer connector. Page 7 MS900AC-B-LS 0714

8 305 Bend Hill Road Fredonia, PA U.S.A Grace Industries, Inc. Printed in U.S.A. P/N: MS900AC-B-LS UI 0714

Advantium 2 Plus Alarm

ADI 9510-B Advantium 2 Plus Alarm INSTALLATION AND OPERATING INSTRUCTIONS Carefully Read These Instructions Before Operating Carefully Read These Controls Corporation of America 1501 Harpers Road Virginia