SAFETY DATA SHEET. Not available. Emergency phone number Chemtrec, US Chemtrec, outside of US

Transcription

1 SAFETY DATA SHEET 1. Identification of the product GHS product identifier Other means of identification Product code Chase BLH20CK A162A Recommended use of the chemical and restrictions on use Recommended use Strand Filler for Wire and Cable Recommended restrictions ne known. Suppliers details Company name CHASE CORPORATION Blawnox Plant Address 128 1st Street Blawnox, PA United States Telephone Emergency phone number Chemtrec, US Chemtrec, outside of US 2. Hazard identification Classification of the substance or mixture t classified. Physical hazards Health hazards Environmental hazards t classified. t classified. GHS label elements, including precautionary statements ne. Hazard symbols Signal word Hazard statement Precautionary statement Prevention Response Storage Disposal Other hazards which do not result in classification Supplemental information ne. The mixture does not meet the criteria for classification. Observe good industrial hygiene practices. Wash hands after handling. Store away from incompatible materials. Dispose of waste and residues in accordance with local authority requirements. ne known. ne. 3. Composition/information on ingredients Mixtures 1 / 6

2 Chemical identity Common name(s), synonym(s) CARBON BLACK Other components below reportable levels CAS number and other unique identifiers Concentration 3 - < First-aid measures Description of necessary first-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. Skin contact Eye contact Ingestion Most important symptoms/effects, acute and delayed Indication of immediate medical attention and special treatment needed General information Wash off with soap and water. Get medical attention if irritation develops and persists. Rinse with water. Get medical attention if irritation develops and persists. Rinse mouth. Get medical attention if symptoms occur. Coughing. Treat symptomatically. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. 5. Fire-fighting measures Suitable extinguishing media Unsuitable extinguishing media Specific hazards arising from the chemical Special protective actions for firefighters Fire fighting equipment/instructions Specific methods General fire hazards Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Do not use water jet as an extinguisher, as this will spread the fire. During fire, gases hazardous to health may be formed. Self-contained breathing apparatus and full protective clothing must be worn in case of fire. Move containers from fire area if you can do so without risk. Use standard firefighting procedures and consider the hazards of other involved materials. unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures For non-emergency Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of personnel low areas. Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. For personal protection, see section 8 of the SDS. For emergency responders Keep unnecessary personnel away. Use personal protection recommended in Section 8 of the SDS. Environmental precautions Methods and materials for containment and cleaning up Avoid discharge into drains, water courses or onto the ground. Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth and place into containers. Prevent entry into waterways, sewer, basements or confined areas. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. 7. Handling and storage Precautions to ensure safe handling Conditions for safe storage, including any incompatibilities Avoid prolonged exposure. Observe good industrial hygiene practices. Store in original tightly closed container. Store away from incompatible materials (see Section 10 of the SDS). 8. Exposure controls/personal protection Control parameters 2 / 6

3 Occupational exposure limits US. ACGIH Threshold Limit Values Components Type Value Form CARBON BLACK (CAS ) Biological limit values Control banding approach Appropriate engineering controls TWA 3 mg/m3 Inhalable fraction. biological exposure limits noted for the ingredient(s). Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Individual protection measures, such as personal protective equipment Eye/face protection Wear safety glasses with side shields (or goggles). Skin protection Hand protection Other Respiratory protection Thermal hazards General hygiene considerations Wear appropriate chemical resistant gloves. Wear suitable protective clothing. In case of insufficient ventilation, wear suitable respiratory equipment. Wear appropriate thermal protective clothing, when necessary. Always observe good personal hygiene measures, such as washing after handling the material and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. 9. Physical and chemical properties Appearance Odor Physical state Form Color Odor threshold ph Melting point/freezing point Initial boiling point and boiling range Flash point Evaporation rate Flammability (solid, gas) Liquid. Liquid F (3642 C) estimated F (101.7 C) estimated Upper/lower flammability or explosive limits Flammability limit - lower (%) Flammability limit - upper (%) Explosive limit - lower (%) Explosive limit - upper (%) Vapor pressure Vapor density Relative density Solubility(ies) Partition coefficient (n-octanol/water) Auto-ignition temperature Decomposition temperature Viscosity hpa estimated F (452 C) estimated 3 / 6

4 Other information Density Percent volatile Specific gravity VOC (Weight %) 10. Stability and reactivity Reactivity Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products 1.80 g/cm3 estimated % estimated 1.8 estimated % estimated The product is stable and non-reactive under normal conditions of use, storage and transport. Material is stable under normal conditions. dangerous reaction known under conditions of normal use. Avoid temperatures exceeding the flash point. Contact with incompatible materials. Chlorine. hazardous decomposition products are known. 11. Toxicological information Information on likely routes of exposure Ingestion Expected to be a low ingestion hazard. Inhalation Skin contact Eye contact Symptoms Information on toxicological effects Acute toxicity Product Chase BLH20CK A162A (CAS Mixture) Acute Oral LD50 Other LD50 Components CARBON BLACK (CAS ) Acute Oral LD50 Prolonged inhalation may be harmful. adverse effects due to skin contact are expected. Direct contact with eyes may cause temporary irritation. Coughing. Species Rat Mouse Species Rat * Estimates for product may be based on additional component data not shown. Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Respiratory sensitization Skin sensitization Germ cell mutagenicity Carcinogenicity ACGIH Carcinogens Prolonged skin contact may cause temporary irritation. Direct contact with eyes may cause temporary irritation. CARBON BLACK (CAS ) This product is not expected to cause skin sensitization. IARC Monographs. Overall Evaluation of Carcinogenicity CARBON BLACK (CAS ) Test Results mg/kg estimated mg/kg estimated Test Results > 8000 mg/kg data available to indicate product or any components present at greater than 0.1% are mutagenic or genotoxic. This product is not considered to be a carcinogen by IARC, ACGIH, NTP, or OSHA. A3 Confirmed animal carcinogen with unknown relevance to humans. 2B Possibly carcinogenic to humans. 4 / 6

5 Reproductive toxicity Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard Other information This product is not expected to cause reproductive or developmental effects. t classified. t classified. 12. Ecological information Ecotoxicity Product Chase BLH20CK A162A (CAS Mixture) Aquatic Fish The product is not classified as environmentally hazardous. However, this does not exclude the possibility that large or frequent spills can have a harmful or damaging effect on the environment. LC50 Species Fish Test Results mg/l, 96 hours estimated * Estimates for product may be based on additional component data not shown. Persistence and degradability Bioaccumulative potential Mobility in soil Other adverse effects 13. Disposal considerations Disposal methods Disposal instructions data is available on the degradability of this product. data available. other adverse environmental effects (e.g. ozone depletion, photochemical ozone creation potential, endocrine disruption, global warming potential) are expected from this component. Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Local disposal regulations Dispose in accordance with all applicable regulations. Hazardous waste code Waste from residues / unused products Contaminated packaging 14. Transport information ANTT t regulated as dangerous goods. DOT t regulated as dangerous goods. SCT t regulated as dangerous goods. IATA t regulated as dangerous goods. IMDG t regulated as dangerous goods. Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code 15. Regulatory information The waste code should be assigned in discussion between the user, the producer and the waste disposal company. Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions). Empty containers should be taken to an approved waste handling site for recycling or disposal. Since emptied containers may retain product residue, follow label warnings even after container is emptied. This substance/mixture is not intended to be transported in bulk. International regulations Montreal Protocol t applicable. Stockholm Convention t applicable. 5 / 6

6 Rotterdam Convention t applicable. Kyoto protocol t applicable. Basel Convention t applicable. International Inventories Country(s) or region Inventory name On inventory (yes/no)* Australia Australian Inventory of Chemical Substances (AICS) Canada Canada China Europe Europe Japan Korea New Zealand Philippines United States & Puerto Rico Domestic Substances List (DSL) n-domestic Substances List (NDSL) Inventory of Existing Chemical Substances in China (IECSC) European Inventory of Existing Commercial Chemical Substances (EINECS) European List of tified Chemical Substances (ELINCS) Inventory of Existing and New Chemical Substances (ENCS) Existing Chemicals List (ECL) New Zealand Inventory Philippine Inventory of Chemicals and Chemical Substances (PICCS) Toxic Substances Control Act (TSCA) Inventory *A "" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) A "" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s). 16. Other information List of abbreviations Disclaimer The information offered in this data sheet is designed only as guidance for the safe use, storage and handling of the product. This information is correct to the best of our knowledge and belief at the date of publication, however, no guarantee is made to its accuracy. This information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any other process. This material is intended for industrial use only. warranty, expressed or implied is made. 6 / 6