TYPE CERTIFICATE DATA SHEET Nº EA-2011T03 Type Certificate Holder: COSTRUZIONI AERONAUTICHE TECNAM S.r.l. Via Tasso, Napoli Italy

Transcription

1 TYPE CERTIFICATE DATA SHEET Nº EA-2011T03 Type Certificate Holder: COSTRUZIONI AERONAUTICHE TECNAM S.r.l. Via Tasso, Napoli Italy EA-2011T03-02 Sheet 01 TECNAM P2006T 04 May 2012 This data sheet, which is part of Type Certificate No. 2011T03, prescribes conditions and limitations under which the product, for which the Type Certificate was issued, meets the airworthiness requirements of the Brazilian Aeronautical Regulations. I - Model P2006T (Normal Category), approved 18 March ENGINES FUEL Two Bombardier Rotax GmbH 912 S3 (EM-2000T02) 100/100LL minimum grade aviation gasoline ENGINE LIMITS Max rotational speed (5 min) r.p.m. (98.6 hp) Max continuous rotational speed r.p.m. (92.5 hp) (Engine shaft r.p.m.) PROPELLER PROPELLER LIMITS OIL COOLANT Two MT Propeller MTV-21-A-C-F/CF (EH-1999T01-01) Two blades, constant speed, variable pitch with feathering capability, wood construction. Diameter: 1780 mm (70.08 inches) no reduction allowed Low Pitch Setting 10 o Feather Position 82 o Lubricant specifications and grade are detailed into the Rotax Operators Manual OM-912 and in its related documents. Water / Cooler Protection For more details see AFM, 2006/044, Section 2

2 TECNAM 04 May 2012 EA-2011T03-02 Sheet 2/5 AIRSPEED LIMITS (CAS) KCAS KIAS Design Manoeuvring Speed (V A ): Flaps extended Speed (V FE ) (landing) (Take off) Minimum Control Speed (V MC ) Maximum Land. Gear Op. Speed (V LO ) Maximum Land. Gear Ext.Speed (V LE ) Maximum Structural Cruising Speed(V NO ) Never Exceed Speed (V NE ) The following values apply when EASA Major Change Approval n Increment of the maximum take off weight (1230 Kg) as per C.A. Tecnam Mod2006/015 is installed (other air Speeds remain unchanged) Design Manoeuvring Speed (V A ): Flaps extended Speed (V FE ) (landing) (Take off) Maximum Structural Cruising Speed(V NO ) Never Exceed Speed (V NE ) KCAS KIAS C. G. RANGE Forward Limit 0,221 m (8.7 in) (16,5 % MAC) behind Datum Rear Limit 0,415 m (16.34 in) (31,0 % MAC) behind Datum. DATUM Wing leading edge MAC = m (52.72 in) LEVELLING MEANS EMPTY WEIGHT C. G. RANGE Seat support trusses (see AFM, 2006/044, Sect. 6 for the procedure) None MAXIMUM WEIGHT Takeoff kg (2 600 lb) Zero Fuel kg (2 524 lb) Landing kg (2 600 lb) The following values apply when EASA Major Change Approval n Increment of the maximum take off weight (1230 Kg) as per C.A. Tecnam Mod2006/015 is installed Takeoff Zero Fuel Landing kg (2 712 lb) kg (2 635 lb) kg (2 712 lb) MINIMUM CREW MAXIMUM PASSENGER 1 pilot 3

3 TECNAM 04 May 2012 EA-2011T03-02 Sheet 3/5 SEATING CAPACITY BAGGAGE / CARGO COMPARTMENTS Maximum Allowable Load : 80 kg (176.4 lb) Location: 1,215 m (47.83 in) aft the datum FUEL CAPACITY OIL CAPACITY (each engine) CONTROL SURFACE MOVEMENTS (*) S/N S ELIGIBLE IMPORT ELIGIBILITY CERTIFICATION BASIS Total: 200 liters (52.8 US gal) Usable: 194,4 liters (51.4 US gal) Maximum: 3,0 liters (0.79 US gal) Minimum: 2,0 liters (0.53 US gal) Ailerons 20 o TEU (**) 17 o TED (***) Stabilator 4 o TEU 15 o TED Stabilator Trim Tab 2 o TEU 19 o TED Rudder 26 o RH 26 o LH Rudder Trim Tab 20 o RH 20 o LH Flaps (*) Nominal Values (**) Trailing Edge Up (***) Trailing Edge Down From 001/BR to 999/BR 15 o TED (take-off position) 40 o TED (landing position) A Brazilian Certificate of Airworthiness may be issued on the basis of an EASA Export Certificate on Airworthiness (or a third country Export Certificate on Airworthiness, in case of used aircraft imported from such country), including the following statement: The aircraft covered by this certificate has been inspected, tested and found to be in conformity with the Brazilian approved type design as defined by the ANAC Type Certificate no. 2011T03 and in condition of safe operation. The ANAC Report H , dated 17 February 2011, or further respective revisions, contain the Brazilian requirements for the acceptance of these airplanes. (See note 7) The certification basis for the aircraft model is RBAC 21 Section 21.29, Brazilian Aeronautical Certification Regulations, including the following Brazilian Aeronautical Certification Regulations: - RBAC 23, which endorses the 14 CFR Part 23 effective on 1 February including Amendments 23.1 through and are similar to CS-23, Decision no. 2003/14/RM effective 14 November 2003; - RBAC 36 which endorses the ICAO, Annex 16, Volume 1, Part II, 4a Edition, July Equivalent Levels of Safety Findings: - EASA CRI D-02 Main Door; - EASA CRI D-01 Ditching Emergency Exits; - EASA CRI D-03 Fire Protection of Flight Controls, engine mounts and other flight structures;

4 TECNAM 04 May 2012 EA-2011T03-02 Sheet 4/5 - EASA CRI E-01 Liquid Cooling Coolant Tank. APPROVED KINDS OF OPERATION PROHIBITED KINDS OF OPERATION Day and Night, Visual Flight Rules (VFR) and Instruments Flight Rules (IFR). Flight into known icing conditions. MAXIMUM OPERATING ALTITUDE m (14,000 ft). At altitudes between m (12,500 ft) and m (14,000 ft), flight must be limited to 30 minutes, unless the required minimum flight crew is provided with and uses supplemental oxygen for that part of the flight at those altitudes that is for more than 30 minutes duration. REQUIRED EQUIPMENT The basic required equipment, as prescribed in the applicable airworthiness regulations (see Certification Basis) must be installed in the airplane. Such equipment is listed in the current ANAC approved Airplane Flight Manual (or Supplemental AFM): 2006/044 ed2 rev3 or later approved revisions. NOTES: NOTE 1 Weight and balance. Current weight and balance report, including list of equipment included in certificated empty weight and loading instructions when necessary, must be provided for each aircraft at the time of original certification. The certificated empty weight and corresponding center of gravity location must include: - Unusable fuel 3,99 kg (8.8 lb) at 0,75 m (29.7 in.) aft of datum - Full oil 5,39 kg (11.9 lb.) at 0,59 m (23.27 in.) aft of datum NOTE 2 AFM, Markings and placards. The placards specified in the approved Brazilian Aircraft Flight Manual No. 2006/044 edition 2 revision 3, dated Mar. 01,2011 (or later EASA approved revision), including the placards in Portuguese specified in the Brazilian Aircraft Flight Manual Supplements No. A17 and No. G8 must be displayed in the specified locations. All required placards are included in Section 2 of the Brazilian AFM and in the Annex C of the report No. H Brazilian Requirements for the Acceptance of the Costruzioni Aeronautiche Tecnam S.r.L.Model P2006T. NOTE 3 Continuing Airworthiness. Information essential to the proper maintenance of the aircraft is contained in the Manufacturer s Maintenance Manual provided with the aircraft. The approved service lives, mandatory inspection and other approved supplemental procedures are listed in approved Chapter 4, Airworthiness Limitation Section of the P2006T Aircraft Maintenance Manual Doc.No. 2006/045, 2nd Edition Rev. 0 October 10th, 2010 approved by the EASA and accepted by ANAC.

5